hempel product data sheets

HEMPADUR MASTIC 45880/45881
Specific Notes for overcoating with HEMPATHANE TOPCOATS:
°i) Depending on actual local conditions, extended maximum recoating intervals may
apply. Please contact HEMPEL for further advice.
°ii) The MIO version, colour no. 12430, may provide extended recoating properties if
HEMPADUR MASTIC 45880/45881 in shade 12430 is applied in a film thickness
that allows a MIO structure to develop. This is typically achieved in a dry film
thickness range of 50-100 micron/2-4 mils for which reason further thinning is
relevant. Reference is made to page 3.
Prior to application of HEMPATHANEs it is mandatory to clean the surface thoroughly to
ensure that any contamination in the rough MIO surface structure is removed.
To determine whether the quality of the surface cleaning is adequate, a test patch may
be relevant. However, such a test is not the final proof of long-term durability, but if the
result is doubtful, repeated cleaning will be relevant. A more safe solution could be to
refresh the surface with a new thin (diluted) coat of HEMPADUR MASTIC 45880/45881.
The MIO concept is typically for use as a “travel coat” on industrial objects.
The dark shade of the MIO pigment should be taken into account when selecting
subsequent shades.
For typical marine coatings, prolonged overcoating intervals can be obtained by using
HEMPADUR 45080 as a preceding coat.
General notes on prolonged recoating intervals:
Besides the notes stated under the tables for minimum recoating intervals, the
following applies:
A completely clean surface is mandatory to ensure intercoat adhesion, especially in
thecase of long recoating intervals. Any dirt, oil and grease have to be removed with eg
suitable detergent followed by high pressure fresh water cleaning. Salts to be removed
by fresh water hosing.
Any degraded surface layer, as a result of a long exposure period, must be removed
as well. Water jetting may be relevant to remove any degraded surface layer and may
also replace the above-mentioned cleaning methods when properly executed. Consult
HEMPEL for specific advice if in doubt.
To determine whether the quality of the surface cleaning is adequate, a test patch may
be relevant, however, this test patch should not be a final proof of the durability of the
coating systems.
Safety: Handle with care. Before and during use, observe all safety labels on packaging and
paint containers, consult HEMPEL Material Safety Data Sheets and follow all local or
national safety regulations. Avoid inhalation, avoid contact with skin and eyes, and do
not swallow. Take precautions against possible risks of fire or explosions as well as
protection of the environment. Apply only in well ventilated areas.
Issued: June 2001 - 4588012170CO009/ 4588112170C0006
HEMPEL’S MARINE PAINTS A/S
This Product Data Sheet supersedes those previously issued. For definition and scope, see explanatory notes to
applicable Product Data Sheets.
Data, specifications, directions and recommendations given in this data sheet represent only test results or
experience obtained under controlled or specially defined circumstances. Their accuracy, completeness or
appropriateness under the actual conditions of any intended use of the Products herein must be determined
exclusively by the Buyer and/or User. The Products are supplied and all technical assistance is given subject to
Issued:
HEMPEL's GENERAL CONDITIONS
June
OF
2001
SALES, DELIVERY AND SERVICE, unless otherwise expressly agreed in writing.
The Manufacturer and Seller disclaim, and Buyer and/or User waive all claims involving, any liability, including but not
limited to negligence, except as expressed in said GENERAL CONDITIONS for all results, injury or direct or
consequential losses or damages arising from the use of the Products as recommended above, on the overleaf or
otherwise.
Product data are subject to change without notice and become void five years from the date of issue.
6/6