hempel product data sheets

2. HEMPEL’S MARINE VARNISH 02220
SURFACE New wood: Saturate the dry surface with a commercial antimould fluid, preferably made from
PREPARATION: fungicide dissolved in white spirit. Apply one coat HEMPEL’S MARINE VARNISH 02220 thinned with
20% THINNER 08230. Apply a second coat HEMPEL'S MARINE VARNISH 02220 thinned 5-10%.
Finally apply 3-5 coats HEMPEL'S MARINE VARNISH 02220 undiluted.
For the best result rub with dry or wet fine sandpaper and dust off between coats for a smooth
finish.
Previously varnished wood: Wash surface with suitable cleaning agent. Do not use detergents
unless they are removed completely, as otherwise residues can spoil the drying properties and give
adhesion problems. Proceed as for new wood. In some cases the antimould treatment and the first
thinned coats can be omitted.
Note: Ammonia water may discolour oak, mahogany and teak.
APPLICATION The surface must be completely clean and dry. Do not apply under humid conditions or at
CONDITIONS: temperatures below 5°C/41°F. The moisture content in the wood should not exceed 16%.
SUBSEQUENT None.
COAT:
REMARKS:
Recoating: Maximum recoating intervals related to later conditions of exposure (20°C/68°F):
02220
Surface temperature
Recoated with
(Quality nos only)
Mild
None
20°C/68°F
Atmospheric
Medium
2 days
If the maximum recoating interval is exceeded, rub down the surface to ensure adhesion.
Note: HEMPEL'S MARINE VARNISH 02220 is for professional use only.
ISSUED: October 1999 - 0222000000CO010
HEMPEL’S MARINE PAINTS A/S
This Product Data Sheet supersedes those previously issued. For definition and scope, see explanatory notes to
applicable Product Data Sheets.
Data, specifications, directions and recommendations given in this data sheet represent only test results or experience
obtained under controlled or specially defined circumstances. Their accuracy, completeness or appropriateness under
the actual conditions of any intended use of the Products herein must be determined exclusively by the Buyer and/or
User. The Products are supplied and all technical assistance is given subject to HEMPEL's GENERAL CONDITIONS OF
SALES, DELIVERY AND SERVICE, unless otherwise expressly agreed in writing. The Manufacturer and Seller disclaim, and
Buyer and/or User waive all claims involving, any liability, including but not limited to negligence, except as expressed in
said GENERAL CONDITIONS for all results, injury or direct or consequential losses or damages arising from the use of
the Products as recommended above, on the overleaf or otherwise.
Product data are subject to change without notice and become void five years from the date of issue.
2/2