hempel product data sheets

2. HEMPADUR VARNISH 05170
SURFACE The surfaces to be treated must be clean and dry and free from grease and oil. Remove loose
PREPARATION: material.
New wood: If necessary the surface should be sanded. Carefully remove the dust.
Previously varnished wood: If the type of old varnish is unknown, but hard and intact it might be
possible to apply HEMPADUR VARNISH 05170 on top. It is recommended first to apply HEMPADUR
VARNISH 05170 on a small area. If required, cleaning is done with a suitable detergent followed by
a very careful removal of all remnants of detergent, dirt etc. Usually the surface will furthermore
need sanding, followed by a careful removal of dust.
APPLICATION Surface saturation: It is recommended to saturate absorbent surfaces with a layer of
CONDITIONS: HEMPADUR VARNISH 05170 diluted 80% with THINNER 08570. May be topcoated after min.
approx. 20 hours (20°C/68°F).
Application method: When treating floors, the mixture may be poured out on the surface and then
levelled with a roller made of hard rubber.
Conditions: Use only where application and curing can proceed at temperatures above 10°C/50°F.
Moisture content of the wood should be below 16%.
SUBSEQUENT Usually none.
COAT:
REMARKS:
Film thickness: The main purpose of the treatment with HEMPADUR VARNISH 05170 is rather to impregnate the
wooden surface than to produce a lacquer layer on top of it.
Recoating: If two coats have to be applied then apply the second coat within 3 days at 20°C/68°F.
Avoid contamination between layers.
Notes: Exposure to sunshine will cause yellowing.
HEMPADUR VARNISH 05170 is for professional use only.
ISSUED: October 1999 - 0517000000CR001
HEMPEL’S MARINE PAINTS A/S
This Product Data Sheet supersedes those previously issued. For definition and scope, see explanatory notes to
applicable Product Data Sheets.
Data, specifications, directions and recommendations given in this data sheet represent only test results or experience
obtained under controlled or specially defined circumstances. Their accuracy, completeness or appropriateness under
the actual conditions of any intended use of the Products herein must be determined exclusively by the Buyer and/or
User. The Products are supplied and all technical assistance is given subject to HEMPEL's GENERAL CONDITIONS OF
SALES, DELIVERY AND SERVICE, unless otherwise expressly agreed in writing. The Manufacturer and Seller disclaim, and
Buyer and/or User waive all claims involving, any liability, including but not limited to negligence, except as expressed in
said GENERAL CONDITIONS for all results, injury or direct or consequential losses or damages arising from the use of
the Products as recommended above, on the overleaf or otherwise.
Product data are subject to change without notice and become void five years from the date of issue.
2/2