Catalyst Sun Blade Computer Upgrade Manual - Zzybot.net

More documents

Recommendations

Info

For steps 2 and 3, refer to the picture Short and Long Brackets.2) Using a #2 Phillips screwdriver, remove the short L-bracket from the rearof the tray section.Short and Long Brackets3) Using a 3/8 in. nut driver, remove the long L-bracket from the rear of thetray section.4) Unhinge the top section from the base section. Refer to the figureComputer Mounting Sled Components.28 Catalyst Sun Blade Computer Upgrade Manual
5) From the service side, mount the tray section (474-239-00) to cage nutlocations 33 and 34 on the left rail and second tapped thread on the rightside of the card cage using three #10-32 screws (470-296-01). Refer tofigure Tray (Service Side).6) Torque the three screws to 30 in-lb.Tray (Service Side)7) On the operator side, mount the short L-bracket to cage nut location 33 onthe right rail and secure it to the tray section with #10-32 screws. Torquethe three screws to 30 in-lb.Catalyst Sun Blade Computer Upgrade Manual 29
Page 1 and 2: Catalyst Sun Blade Computer Upgrade
Page 3 and 4: Prepare for InstallationThis topic
Page 5 and 6: Lockout Sequence1) When servicing i
Page 7 and 8: A. TagD. Connector BootB. HaspB. Ha
Page 9 and 10: Remove the Test System CoversRemovi
Page 11 and 12: 9) Disconnect cable 804-182-00 from
Page 13 and 14: Removing the Ultra 10/60 Test Compu
Page 15 and 16: 3) Remove the upper retaining brack
Page 17 and 18: On the operator side perform steps
Page 19 and 20: Transfer the PCI CardsWhen upgradin
Page 21 and 22: 5) Using a Phillips head screwdrive
Page 23 and 24: Installing the Ethernet SwitchThis
Page 25 and 26: Installing the Sun Blade 2500 Test
Page 27: 3) Plug the power cable (807-372-00
Page 31 and 32: 9) Torque the nuts to 30 in-lb.10)
Page 33 and 34: Sun Blade Mounting SledSecuring Top
Page 35 and 36: 6) Insert a 1/4-20 screw through th
Page 37 and 38: Installing the Sun Blade 2500 Test
Page 39 and 40: 5) From the service side, mount the
Page 41 and 42: Install the Sun Blade 2500 Test Com
Page 43 and 44: 4) Secure the Sun Blade 2500 to the
Page 45 and 46: 6) Insert a 1/4-20 screw through th
Page 47 and 48: Connect the Sun Blade 2500 Cables1)
Page 49 and 50: Install the MonitorsMonitor #1Monit
Page 51 and 52: System VerificationOverviewAt this
Page 53 and 54: Changing a Catalyst Test System's N
Page 55 and 56: NoteIf the part is packaged in a va
Page 57 and 58: PPartsHandling Procedures 54Return

Catalyst Sun Blade Computer Upgrade Manual - Zzybot.net

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?