Catalyst Sun Blade Computer Upgrade Manual - Zzybot.net
Catalyst Sun Blade Computer Upgrade Manual - Zzybot.net
Catalyst Sun Blade Computer Upgrade Manual - Zzybot.net
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Connect the <strong>Sun</strong> <strong>Blade</strong> 2500 Cables1) Connect the Ether<strong>net</strong> cable (811-112-00) to the Ether<strong>net</strong> port on the <strong>Sun</strong><strong>Blade</strong> 2500 computer.2) Connect the serial cable (811-115-00) to serial port 1 on the <strong>Sun</strong> <strong>Blade</strong>2500 computer.3) Connect power cable (807-387-02) from the <strong>Sun</strong> <strong>Blade</strong> 2500 computerplug to the outlet strip.4) Connect the Terabus adaptor cable 804-256-00 to the right-handconnector on the Terabus Adaptor Board in PCI slot 0 in the <strong>Sun</strong> <strong>Blade</strong>2500 computer. There is no need to terminate the left connector on theTerabus adaptor board as termination is hard wired to the connector.5) Connect the Terabus cable (800-321-03) to the Terabus adaptor cable(804-256-00).6) Connect the TCIO cable (804-257-00) to the left-hand connector on theBIF board located in PCI slot 1 in the <strong>Sun</strong> <strong>Blade</strong> 2500 computer.7) Connect the TCIO “Y”-cable (804-258-00) to the right-hand connector onthe BIF board located in PCI slot 1 of the <strong>Sun</strong> <strong>Blade</strong> 2500.8) Following the routing path of the previous TCIO cable, attach the otherend of the TCIO cable (804-257-00) to CDM #1 slot 5, rows 67 through72.Remove the old TCIO cable from the system.9) Following the routing path of the previous “Y”-cable, attach one end ofthe “Y”-cable to PACS backplane #1 slot 8, rows 81 through 86.10) Following the routing path of the previous “Y”-cable, attach the other endof the “Y”-cable to connector J13 on the environmental monitoring board(949-703-00) located above the <strong>Sun</strong> <strong>Blade</strong> in the systemmainframe.Remove the old “Y”-cable from the system.11) Connect the GPIB cable (901-090-00) to the GPIB card in PCI slot 2 or 4in the <strong>Sun</strong> <strong>Blade</strong> 2500.12) Connect one end of the RS232 expansion board cable (866-159-00) to theRS232 expansion card in PCI slot 3 in the <strong>Sun</strong> <strong>Blade</strong> 2500.13) Following the routing path of the previous serial cables, mount the DB25connectors at the other end of the 866-159-00 cable to locations J7 throughJ10 on the system bulkhead using the hardware attached to theconnectors.Remove the old serial cables from the system.<strong>Catalyst</strong> <strong>Sun</strong> <strong>Blade</strong> <strong>Computer</strong> <strong>Upgrade</strong> <strong>Manual</strong> 47
Change language