Catalyst Sun Blade Computer Upgrade Manual - Zzybot.net

More documents

Recommendations

Info

2) Set the Sun Blade 2500 computer on the base section of the mountingassembly so that the front of the computer is flush with the down angledtongue and the rear of the computer is flush against the stop angle. See thefigure Sun Blade 2500 and Mounting Assembly.Sun Blade 2500 and Mounting Assembly3) Reinstall the captive screws in the Sun Blade 2500,threading themthrough the holes in the stop angle in the base section. See the figure SunBlade 2500 and Mounting Assembly.42 Catalyst Sun Blade Computer Upgrade Manual
4) Secure the Sun Blade 2500 to the base section by slipping the top sectioninto the upper slot of the base section and catching the hook on the lowerend of the base section. See the figures Sun Blade Mounting Sled andSecuring Top Section.Sun Blade Mounting SledSecuring Top SectionCatalyst Sun Blade Computer Upgrade Manual 43
Page 1 and 2: Catalyst Sun Blade Computer Upgrade
Page 3 and 4: Prepare for InstallationThis topic
Page 5 and 6: Lockout Sequence1) When servicing i
Page 7 and 8: A. TagD. Connector BootB. HaspB. Ha
Page 9 and 10: Remove the Test System CoversRemovi
Page 11 and 12: 9) Disconnect cable 804-182-00 from
Page 13 and 14: Removing the Ultra 10/60 Test Compu
Page 15 and 16: 3) Remove the upper retaining brack
Page 17 and 18: On the operator side perform steps
Page 19 and 20: Transfer the PCI CardsWhen upgradin
Page 21 and 22: 5) Using a Phillips head screwdrive
Page 23 and 24: Installing the Ethernet SwitchThis
Page 25 and 26: Installing the Sun Blade 2500 Test
Page 27 and 28: 3) Plug the power cable (807-372-00
Page 29 and 30: 5) From the service side, mount the
Page 31 and 32: 9) Torque the nuts to 30 in-lb.10)
Page 33 and 34: Sun Blade Mounting SledSecuring Top
Page 35 and 36: 6) Insert a 1/4-20 screw through th
Page 37 and 38: Installing the Sun Blade 2500 Test
Page 39 and 40: 5) From the service side, mount the
Page 41: Install the Sun Blade 2500 Test Com
Page 45 and 46: 6) Insert a 1/4-20 screw through th
Page 47 and 48: Connect the Sun Blade 2500 Cables1)
Page 49 and 50: Install the MonitorsMonitor #1Monit
Page 51 and 52: System VerificationOverviewAt this
Page 53 and 54: Changing a Catalyst Test System's N
Page 55 and 56: NoteIf the part is packaged in a va
Page 57 and 58: PPartsHandling Procedures 54Return

Catalyst Sun Blade Computer Upgrade Manual - Zzybot.net

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?