Catalyst Sun Blade Computer Upgrade Manual - Zzybot.net

More documents

Recommendations

Info

8) On the operator side, Mount the L-bracket over the threaded studs on thetray section with keps nuts (470-353-03) so that the “C ’s” engraved in thebracket align with the threaded studs on the tray.Mount the other side ofthe L-bracket to the second tapped thread on the left card cage using a#10-32 screw (470-296-01). Refer to the figures “C” Alignment Marksand Long L-Bracket.“C” Alignment MarksTrayThreaded StudL-BracketLong L-Bracket9) Torque the nuts to 30 in-lbs.10) Secure the L-bracket section to the left card cage with a #10-32 screw.40 Catalyst Sun Blade Computer Upgrade Manual
Install the Sun Blade 2500 Test Computer1) Remove the captive screws from the right side of the rear of the Sun Blade2500 computer. See the figure Thumb Screws.Thumb ScrewThumb ScrewThumb ScrewsCatalyst Sun Blade Computer Upgrade Manual 41
Page 1 and 2: Catalyst Sun Blade Computer Upgrade
Page 3 and 4: Prepare for InstallationThis topic
Page 5 and 6: Lockout Sequence1) When servicing i
Page 7 and 8: A. TagD. Connector BootB. HaspB. Ha
Page 9 and 10: Remove the Test System CoversRemovi
Page 11 and 12: 9) Disconnect cable 804-182-00 from
Page 13 and 14: Removing the Ultra 10/60 Test Compu
Page 15 and 16: 3) Remove the upper retaining brack
Page 17 and 18: On the operator side perform steps
Page 19 and 20: Transfer the PCI CardsWhen upgradin
Page 21 and 22: 5) Using a Phillips head screwdrive
Page 23 and 24: Installing the Ethernet SwitchThis
Page 25 and 26: Installing the Sun Blade 2500 Test
Page 27 and 28: 3) Plug the power cable (807-372-00
Page 29 and 30: 5) From the service side, mount the
Page 31 and 32: 9) Torque the nuts to 30 in-lb.10)
Page 33 and 34: Sun Blade Mounting SledSecuring Top
Page 35 and 36: 6) Insert a 1/4-20 screw through th
Page 37 and 38: Installing the Sun Blade 2500 Test
Page 39: 5) From the service side, mount the
Page 43 and 44: 4) Secure the Sun Blade 2500 to the
Page 45 and 46: 6) Insert a 1/4-20 screw through th
Page 47 and 48: Connect the Sun Blade 2500 Cables1)
Page 49 and 50: Install the MonitorsMonitor #1Monit
Page 51 and 52: System VerificationOverviewAt this
Page 53 and 54: Changing a Catalyst Test System's N
Page 55 and 56: NoteIf the part is packaged in a va
Page 57 and 58: PPartsHandling Procedures 54Return

Catalyst Sun Blade Computer Upgrade Manual - Zzybot.net

Create successful ePaper yourself

Delete template?

Save as template?