Apple Technician Guide MacBook Pro (17-inch, Early 2009) - tim.id.au

4 With computer closed
and flat on table,
check alignment
where the display
meets the top case.
5 If necessary, slightly
loosen the two
center screws, adjust
alignment, and
resecure screws.
6 With the proper
alignment verified,
install the remaining
screws (3-6) in the
order shown while
the computer is still
closed.
Replacement Caution:
When connecting the
LVDS and camera cables,
make sure they are fully
connected. For the camera
cable, place shim behind
connector so it helps
secure the cable.
Replacement Caution: To
prevent no video or a
short to the logic board,
be sure to place EMI
gasket on camera cable—
positioned precisely
where shown—after
cable is fully connected to
logic board and shim is in
place.
2010-06-11
MacBook Pro (17-inch, Early 2009) Take Apart — Display Assembly 167