Apple Technician Guide MacBook Pro (17-inch, Early 2009) - tim.id.au

More documents

Recommendations

Info

2010-06-11 Deep Dive: Vertical/Horizontal Lines Check Result Action Code 1. Horizontal lines may be related to a failing RAM module. Verify if video issue only happens AFTER the Apple logo and the spinning wheel has appeared. 2. Start with shift key down (safe mode) to disable system extensions. Verify if issue still happens when booting in safe mode. 3. Isolate with only one memory module installed , then with the other one. Test with known-good memory. Verify that issue only happens with specific RAM module(s). 4. Isolate with one known-good memory module installed in one of the memory slots. Repeat by testing in the other memory slot with knowngood memory module. Verify that issue only happens with specific memory slot on logic board. 5. Run Clamshell Service Diagnostic utility and check for LCD panel presence. If not found, reseat the LVDS cable to the logic board video output. Is normal video restored? 6. Connect external compatible DisplayPort display (or DisplayPort adapter and display). Verify if correct video appears on external display. 7. Substitute a known-good display assembly module to test logic board LVDS video output. Is normal video restored? Yes Issue only happens AFTER Apple logo and spinning wheel appears. Go to step 2. No Issues happens since startup. Go to step 5. Yes Go to step 5. No No video issue when booting in safe mode. Go to step 3. Yes Replace affected RAM module. No Go to step 4 X02 Yes Replace logic board. M07 No Go to step 5 Yes Issue resolved by reseating loose LVDS cable.. No Go to step 6 Yes Go to step 7. No Replace logic board M04 Yes Replace display assembly module. L05 No Replace logic board. M04 MacBook Pro (17-inch, Early 2009) Symptom Charts — Display 72
2010-06-11 Deep Dive: Non-uniform Brightness Check Result Action Code 1. Determine if brightness uniformity issue is visible after display has warmed up for 15 minutes. 2. Check LVDS cable connection to logic board. 3. Determine if variation in uniformity appears excessive when compared to another similar unit. Yes Go to step 2. No Display backlight can take several minutes to stabilize. Yes Reseat LVDS cable No Got to step 3 Yes Replace display assembly. L07 No Explain to user that LCD appears to meet specifications. MacBook Pro (17-inch, Early 2009) Symptom Charts — Display 73
Page 1 and 2:
apple Apple Technician Guide MacBoo
Page 3 and 4:
MacBook Pro (17-inch, Early 2009) C
Page 5 and 6:
Specific Keys Don’t Work 95 Built
Page 7 and 8:
Replacement 203 Left Speaker 205 Mi
Page 9 and 10:
2010-06-11 Take Apart: • Connecto
Page 11 and 12:
apple Apple Technician Guide Basic
Page 13 and 14:
2010-06-11 • Product identificati
Page 15 and 16:
2010-06-11 Serial Number Location S
Page 17 and 18:
2010-06-11 General Information Requ
Page 19 and 20:
apple Apple Technician Guide Troubl
Page 21 and 22: 2010-06-11 Troubleshooting Theory F
Page 23 and 24: 2010-06-11 1920x1200 LCD Display Di
Page 25 and 26: 2010-06-11 Liquid Submersion Indica
Page 27 and 28: 2010-06-11 Resetting the Parameter
Page 29 and 30: 2010-06-11 Display Hinge Behavior T
Page 31 and 32: 2010-06-11 Deep Dive Check Result A
Page 33 and 34: 2010-06-11 Won’t Start Up Unlikel
Page 35 and 36: 2010-06-11 8. Use Disk Utility load
Page 37 and 38: 2010-06-11 Suggested steps for trou
Page 39 and 40: 2010-06-11 5. Check system running
Page 43 and 44: 2010-06-11 9. Check for No Backligh
Page 45 and 46: 2010-06-11 4. Does battery status i
Page 47 and 48: 2010-06-11 Kernel Panic/System Cras
Page 49 and 50: 2010-06-11 6. Disconnect display as
Page 51 and 52: 2010-06-11 Power Adapter Issue Unli
Page 53 and 54: 2010-06-11 3. Disconnect any periph
Page 55 and 56: 2010-06-11 3. Is the computer opera
Page 57 and 58: 2010-06-11 2. Isolate OS by booting
Page 59 and 60: 2010-06-11 2. Run Clamshell Service
Page 61 and 62: 2010-06-11 3. Verify the antenna co
Page 63 and 64: 2010-06-11 8. Continue to test a kn
Page 65 and 66: 2010-06-11 Wireless Performance Iss
Page 67 and 68: 2010-06-11 Wireless Input Device Do
Page 69 and 70: 2010-06-11 Display Display Anomalie
Page 71: 2010-06-11 7. Substitute a known-go
Page 75 and 76: 2010-06-11 Blank / No Video Unlikel
Page 77 and 78: 2010-06-11 4. Swap memory with know
Page 79 and 80: 2010-06-11 Cosmetic Defects Quick C
Page 81 and 82: 2010-06-11 4. After reseating hard
Page 83 and 84: 2010-06-11 Hard Drive Noisy Unlikel
Page 87 and 88: 2010-06-11 2. Can optical drive rea
Page 89 and 90: 2010-06-11 Optical Drive Noisy Unli
Page 91 and 92: 2010-06-11 Optical Drive Not Perfor
Page 93 and 94: 2010-06-11 Input/Output Devices USB
Page 95 and 96: 2010-06-11 3. Disconnect and verify
Page 97 and 98: 2010-06-11 6. Does the select butto
Page 101 and 102: 2010-06-11 6. Does a known-good tra
Page 105 and 106: 2010-06-11 Express Card Will Not In
Page 107 and 108: 2010-06-11 FireWire Port Not Recogn
Page 109 and 110: 2010-06-11 2. Remove battery and AC
Page 111 and 112: 2010-06-11 8. Inspect and reseat co
Page 113 and 114: Vertical Insertion (JST) • Use bl
Page 115 and 116: Replacement Caution: When connectin
Page 117 and 118: First Steps Warning: • Shut down
Page 119 and 120: 2 Remove 10 screws: • 3 (13.5 mm)
Page 121 and 122: 2 Install bottom case so that 4 cli
Page 123 and 124:
Removal Important: Battery removal
Page 125 and 126:
Replacement 1 Slide front edge of b
Page 127 and 128:
First Steps Remove: • Bottom case
Page 129 and 130:
Page 131 and 132:
3 Hold hard drive by the sides only
Page 133 and 134:
2010-06-11 Reinstalling Software th
Page 135 and 136:
Tools • Clean, soft, lint-free cl
Page 137 and 138:
2 Press card down. 3 If you install
Page 139 and 140:
Tools Clean, soft, lint-free cloth
Page 141 and 142:
Replacement 1 Remove any adhesive r
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Replacement Caution: When connectin
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
5 Flip over board. 6 Lift lever to
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
7 Open the display to 90 degrees, a
Page 167 and 168:
4 With computer closed and flat on
Page 169 and 170:
Page 171 and 172:
4 Tilt up end of clutch cover as yo
Page 173 and 174:
Refer to AirPort Card 2010-06-11 Ca
Page 175 and 176:
Removal 1 Cover display with clean,
Page 177 and 178:
3 Place the cable in the clip befor
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
3 Refer to Connector Types to caref
Page 187 and 188:
Replacement If replacing the logic
Page 189 and 190:
Removal 1 Remove 6 #000 (2-mm) Phil
Page 191 and 192:
9 Tilt up top case, and spiral trac
Page 193 and 194:
3 Slide stiffeners over the flexure
Page 195 and 196:
9 Fold sticky notes over so that to
Page 197 and 198:
Page 199 and 200:
Replacement Caution: Plug in a disc
Page 201 and 202:
Page 203 and 204:
4 With a black stick, scrape off th
Page 205 and 206:
Page 207 and 208:
2 Remove 2 (8.1-mm) 922-8720 screws
Page 209 and 210:
Removal Note: Do not touch the soft
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
apple Apple Technician Guide Views
Page 217 and 218:
2010-06-11 Main Assembly, 2 of 2: M
Page 219 and 220:
2010-06-11 Bottom Case 922-9024 Blu
Page 221 and 222:
2010-06-11 External Views Front Vie
Page 223 and 224:
2010-06-11 Screw Location Diagrams
Page 225 and 226:
2010-06-11 Display Assembly All scr
show all

Apple Technician Guide MacBook Pro (17-inch, Early 2009) - tim.id.au

Create successful ePaper yourself

Delete template?

Save as template?