Apple Technician Guide MacBook Pro (17-inch, Early 2009) - tim.id.au

More documents

Recommendations

Info

2010-06-11 Transferring the Serial Number When replacing a bottom case, retain the customer’s bottom case until the repair is complete. Before installing the replacement bottom case, use a fine tip permanent marker to write the original serial number clearly and legibly in uppercase box letters directly onto the inside of the new bottom case. CAUTION: Take great care in deciphering the small typeface of the etched serial number on the bottom case. You might need a magnifying glass to see it clearly. It is imperative that you transfer the correct alphanumeric characters. Keep in mind that Apple serial numbers always use the numbers 1 and 0 instead of the Roman letters “I” and “O.” MacBook Pro (17-inch, Early 2009) Basics — Serial Number Location 16
2010-06-11 General Information Required Tools Caution: To prevent scratches or other cosmetic damage to the computer housing, use a soft cloth as a protective layer when removing and installing the external screws. The following tools are required to service the computer: • Clean, soft, lint-free cloth • ESD wrist strap and mat • Magnetic Phillips #0 screwdriver • Magnetic Phillips #00 screwdriver (preferably with a long handle) • Torx T6 screwdriver • Large tri-lobe #0 screwdriver (Apple part number 922-8991) • Black stick (Apple probe tool, part number 922-5065) or other nonconductive nylon or plastic flatblade tool • EMI-safe plastic or nylon tweezers for installing flex cables (optional) • Thermal grease (Apple thermal compound syringe, part number 922-7144) • Alcohol wipes • Permanent marking, felt-tip pen • Pencil with eraser • Foam wedge fixture for display assembly removal (Apple part number 922-8779) • Kapton tape • Tweezers, ESD safe, extra fine points, for flat cable replacement • Magnifying glass, for reading serial number etched on bottom case • Digital volt meter (troubleshooting) Refer to Knowledge Base article “Hand Tools for Desktop and Portable Repairs--AP/CA/EU/JP/ LA/US” to purchase tools: http://support.apple.com/kb/HT3452 In addition, the following software programs are required for troubleshooting: • Apple Service Diagnostic (ASD), version 3S132 or later • Apple Hardware Test, version 3A175 or later MacBook Pro (17-inch, Early 2009) Basics — General Information 17
Page 1 and 2: apple Apple Technician Guide MacBoo
Page 3 and 4: MacBook Pro (17-inch, Early 2009) C
Page 5 and 6: Specific Keys Don’t Work 95 Built
Page 7 and 8: Replacement 203 Left Speaker 205 Mi
Page 9 and 10: 2010-06-11 Take Apart: • Connecto
Page 11 and 12: apple Apple Technician Guide Basic
Page 13 and 14: 2010-06-11 • Product identificati
Page 15: 2010-06-11 Serial Number Location S
Page 19 and 20: apple Apple Technician Guide Troubl
Page 21 and 22: 2010-06-11 Troubleshooting Theory F
Page 23 and 24: 2010-06-11 1920x1200 LCD Display Di
Page 25 and 26: 2010-06-11 Liquid Submersion Indica
Page 27 and 28: 2010-06-11 Resetting the Parameter
Page 29 and 30: 2010-06-11 Display Hinge Behavior T
Page 31 and 32: 2010-06-11 Deep Dive Check Result A
Page 33 and 34: 2010-06-11 Won’t Start Up Unlikel
Page 35 and 36: 2010-06-11 8. Use Disk Utility load
Page 37 and 38: 2010-06-11 Suggested steps for trou
Page 39 and 40: 2010-06-11 5. Check system running
Page 41 and 42: 2010-06-11 Deep Dive Check Result A
Page 43 and 44: 2010-06-11 9. Check for No Backligh
Page 45 and 46: 2010-06-11 4. Does battery status i
Page 47 and 48: 2010-06-11 Kernel Panic/System Cras
Page 49 and 50: 2010-06-11 6. Disconnect display as
Page 51 and 52: 2010-06-11 Power Adapter Issue Unli
Page 53 and 54: 2010-06-11 3. Disconnect any periph
Page 55 and 56: 2010-06-11 3. Is the computer opera
Page 57 and 58: 2010-06-11 2. Isolate OS by booting
Page 59 and 60: 2010-06-11 2. Run Clamshell Service
Page 61 and 62: 2010-06-11 3. Verify the antenna co
Page 63 and 64: 2010-06-11 8. Continue to test a kn
Page 65 and 66: 2010-06-11 Wireless Performance Iss
Page 67 and 68:
2010-06-11 Wireless Input Device Do
Page 69 and 70:
2010-06-11 Display Display Anomalie
Page 71 and 72:
2010-06-11 7. Substitute a known-go
Page 73 and 74:
2010-06-11 Deep Dive: Non-uniform B
Page 75 and 76:
2010-06-11 Blank / No Video Unlikel
Page 77 and 78:
2010-06-11 4. Swap memory with know
Page 79 and 80:
2010-06-11 Cosmetic Defects Quick C
Page 81 and 82:
2010-06-11 4. After reseating hard
Page 83 and 84:
2010-06-11 Hard Drive Noisy Unlikel
Page 85 and 86:
2010-06-11 Deep Dive Check Result A
Page 87 and 88:
2010-06-11 2. Can optical drive rea
Page 89 and 90:
2010-06-11 Optical Drive Noisy Unli
Page 91 and 92:
2010-06-11 Optical Drive Not Perfor
Page 93 and 94:
2010-06-11 Input/Output Devices USB
Page 95 and 96:
2010-06-11 3. Disconnect and verify
Page 97 and 98:
2010-06-11 6. Does the select butto
Page 99 and 100:
Page 101 and 102:
2010-06-11 6. Does a known-good tra
Page 103 and 104:
Page 105 and 106:
2010-06-11 Express Card Will Not In
Page 107 and 108:
2010-06-11 FireWire Port Not Recogn
Page 109 and 110:
2010-06-11 2. Remove battery and AC
Page 111 and 112:
2010-06-11 8. Inspect and reseat co
Page 113 and 114:
Vertical Insertion (JST) • Use bl
Page 115 and 116:
Replacement Caution: When connectin
Page 117 and 118:
First Steps Warning: • Shut down
Page 119 and 120:
2 Remove 10 screws: • 3 (13.5 mm)
Page 121 and 122:
2 Install bottom case so that 4 cli
Page 123 and 124:
Removal Important: Battery removal
Page 125 and 126:
Replacement 1 Slide front edge of b
Page 127 and 128:
First Steps Remove: • Bottom case
Page 129 and 130:
Page 131 and 132:
3 Hold hard drive by the sides only
Page 133 and 134:
2010-06-11 Reinstalling Software th
Page 135 and 136:
Tools • Clean, soft, lint-free cl
Page 137 and 138:
2 Press card down. 3 If you install
Page 139 and 140:
Tools Clean, soft, lint-free cloth
Page 141 and 142:
Replacement 1 Remove any adhesive r
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Replacement Caution: When connectin
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
5 Flip over board. 6 Lift lever to
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
7 Open the display to 90 degrees, a
Page 167 and 168:
4 With computer closed and flat on
Page 169 and 170:
Page 171 and 172:
4 Tilt up end of clutch cover as yo
Page 173 and 174:
Refer to AirPort Card 2010-06-11 Ca
Page 175 and 176:
Removal 1 Cover display with clean,
Page 177 and 178:
3 Place the cable in the clip befor
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
3 Refer to Connector Types to caref
Page 187 and 188:
Replacement If replacing the logic
Page 189 and 190:
Removal 1 Remove 6 #000 (2-mm) Phil
Page 191 and 192:
9 Tilt up top case, and spiral trac
Page 193 and 194:
3 Slide stiffeners over the flexure
Page 195 and 196:
9 Fold sticky notes over so that to
Page 197 and 198:
Page 199 and 200:
Replacement Caution: Plug in a disc
Page 201 and 202:
Page 203 and 204:
4 With a black stick, scrape off th
Page 205 and 206:
Page 207 and 208:
2 Remove 2 (8.1-mm) 922-8720 screws
Page 209 and 210:
Removal Note: Do not touch the soft
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
apple Apple Technician Guide Views
Page 217 and 218:
2010-06-11 Main Assembly, 2 of 2: M
Page 219 and 220:
2010-06-11 Bottom Case 922-9024 Blu
Page 221 and 222:
2010-06-11 External Views Front Vie
Page 223 and 224:
2010-06-11 Screw Location Diagrams
Page 225 and 226:
2010-06-11 Display Assembly All scr
show all

Apple Technician Guide MacBook Pro (17-inch, Early 2009) - tim.id.au

Create successful ePaper yourself

Delete template?

Save as template?