Owner's Manual - Roland
Owner's Manual - Roland
Owner's Manual - Roland
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Creating a Patch<br />
Output Settings<br />
Patch Output<br />
Patch Out Assign<br />
116<br />
Specifies how the direct sound of each patch will be output.<br />
Value:<br />
MFX: Output in stereo through multi-effects. You can<br />
also apply chorus or reverb to the sound that<br />
passes through multi-effects.<br />
L+R: Output in stereo without passing through multieffects.<br />
L, R: Output in mono without passing through multieffects.<br />
TONE: Outputs according to the settings for each tone.<br />
Tone Out Assign<br />
Specifies how the direct sound of each tone will be output.<br />
Value:<br />
MFX: Output in stereo through multi-effects. You can<br />
also apply chorus or reverb to the sound that<br />
passes through multi-effects.<br />
L+R: Output in stereo without passing through multieffects.<br />
L, R: Output in mono without passing through multieffects.<br />
* If the Patch Output Assign is set to anything other than<br />
“TONE,” these settings will be ignored.<br />
* When the Structure Type parameter has a setting of Type<br />
“2”–”10,” the outputs of tones 1 and 2 will be combined with<br />
tone 2, and the outputs of tones 3 and 4 will be combined<br />
with tone 4. For this reason, tone 1 will follow the settings of<br />
tone 2, and tone 3 will follow the settings of tone 4 (p. 101).<br />
* If you’ve set Tone Out Assign to “MFX,” set the MFX Output<br />
Assign parameter to specify the output destination of the<br />
sound that has passed through the multi-effects.<br />
* Sounds are output to chorus and reverb in mono at all times.<br />
* The output destination of the signal after passing through<br />
the chorus is set with the Chorus Output Select.<br />
Tone Out Level<br />
Set the level of the signal that is sent to the output<br />
destination specified by Tone Output Assign.<br />
Value: 0–127<br />
Tone Chorus Send<br />
(Send Level (Output=MFX))<br />
Specifies the level of the signal sent to the chorus for each<br />
tone if the tone is sent through MFX.<br />
Value: 0–127<br />
Tone Reverb Send<br />
(Send Level (Output=MFX))<br />
Specifies the level of the signal sent to the reverb for each<br />
tone if the tone is sent through MFX.<br />
Value: 0–127<br />
Tone Chorus Send<br />
(Send Level (Output=non MFX))<br />
Sets the level of the signal sent to chorus for each tone if the<br />
tone is not sent through MFX.<br />
Value: 0–127<br />
Tone Reverb Send<br />
(Send Level (Output=non MFX))<br />
Sets the level of the signal sent to reverb for each tone if the<br />
tone is not sent through MFX.<br />
Value: 0–127