Owner's Manual - Roland

Panel Descriptions
E. DIGITAL 2 OUT Connector
22
This is an ADAT output connector. You can connect it to an ADAT device and output up to eight channels of audio.
DIGITAL 2 IN Connector
This is an ADAT input connector. It allows up to eight channels of input. The input signals are output directly to the
“VS-700 IN DIGITAL2 1-2” – “VS-700 IN DIGITAL2 7-8” ports of the audio driver.
➔ “Connections to the Digital Connectors” (p. 79)
F. DIGITAL 1 AES/EBU OUT Connector
This is an AES/EBU format two-channel (stereo) digital output. The same signal is also output to the COAXIAL OUT
connector. This will output the signal of the audio driver’s “VS-700 OUT DIGITAL1” port.
DIGITAL 1 AES/EBU IN Connector
This is an AES/EBU format two-channel (stereo) digital input. This is switched with the COAXIAL IN (S/PDIF)
connector. The input signal is output directly to the audio driver’s “VS-700 IN DIGITAL1” port.
➔ “Connections to the Digital Connectors” (p. 79)
DIGITAL 1 COAXIAL OUT Connector
This is an S/PDIF format two-channel (stereo) digital output. The same signal is also output to the AES/EBU connector.
This will output the signal of the audio driver’s “VS-700 OUT DIGITAL1” port.
DIGITAL 1 COAXIAL IN Connector
This is an S/PDIF format two-channel (stereo) digital input. This is switched with the AES/EBU connector. The input
signal is output directly to the audio driver’s “VS-700 IN DIGITAL1” port.
➔ “Connections to the Digital Connectors” (p. 79)
G. WORDCLOCK IN Connector
This is a WORDCLOCK input connector.
WORDCLOCK OUT Connector
For details on checking and selecting the clock source, refer to “Audio Clock Source” (p. 82).
This is a WORDCLOCK output connector. It outputs a clock at all times.
H. OUTPUT 1–10 Jacks
These are ten channels of audio output connectors. They allow a broad range of connections, such as for multioutput
in a surround system, or as sends for outboard effects. These are balanced outputs. They output the signals of
the audio driver’s “1-2 (VS-700)” – “VS-700 OUT 9-10” ports.