Owner's Manual - Roland

Adding Effects
Functions of Effect Parameters
Part Output
1
2
3
4
146
Here you can make output settings for the Performance.
* These parameters are the same as the corresponding
Performance settings. For details, refer to Output Level (Part
Output Level) (p. 137).
Part Output Level
Set the level of the signal that is sent to the output
destination specified by Part Output Assign ( 4 ).
Value: 0–127
Part Chorus Send Level
Sets the level of the signal sent to chorus for each part.
Value: 0–127
Part Reverb Send Level
Sets the level of the signal sent to reverb for each part.
Value: 0–127
Part Output Assign
Specifies for each part how the direct sound will be output.
Value
MFX: Output in stereo through multi-effects. You can
also apply chorus or reverb to the sound that
passes through multi-effects.
L+R: Output in stereo without passing through multieffects.
L, R: Output in mono without passing through multieffects.
PAT: The part’s output destination is determined by
the settings of the patch or rhythm set assigned
to the part.
• Chorus and reverb are output in mono at all times.
• The output destination of the signal after passing through
the chorus is set with the Chorus Output Select ( 12 ).
5
Part Output MFX Select
(Part Output Multi-Effects Select)
Of the three systems of multi-effects that can be used
simultaneously, specify which multi-effects will be used.
Value: 1–3(MFX-1–MFX-3)
MFX1–3
6
For the following parameters 6 – 9 , settings can be
made individually for three systems multi-effects (MFX1–
MFX3).
MFX Type (Multi-Effects Type)
Use this parameter to select from among the 78 available
multi-effects.
Value: 0 (Through)–78