Owner's Manual - Roland
Owner's Manual - Roland
Owner's Manual - Roland
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Creating a Patch<br />
● Changing the Depth of Frequency Modulation<br />
for FXM<br />
124<br />
FXM DEPTH<br />
● Changing Specific Multi-Effects Parameters<br />
MFX CTRL1–4: Change the parameter that was specified by<br />
MFX Control 1–4 Assign parameter.<br />
If you have not made the necessary settings for using<br />
the multi-effect, the multi-effect will not be applied<br />
even if you attempt to control it as a Matrix Control<br />
destination.<br />
● If you’re not using Matrix Control<br />
OFF: Matrix Control will not be used.<br />
CTRL Sens 1–4 (Matrix Control Sens 1–4)<br />
Sets the amount of the Matrix Control’s effect that is applied.<br />
If you wish to modify the selected parameter in a positive (+)<br />
direction – i.e., a higher value, toward the right, or faster etc. –<br />
from its current setting, select a positive (+) value. If you wish<br />
to modify the selected parameter in a negative (-) direction –<br />
i.e., a lower value, toward the left, or slower etc. – from its<br />
current setting, select a negative (-) value. For either positive<br />
or negative settings, greater absolute values will allow<br />
greater amounts of change. Set this to “0” if you don’t want<br />
to apply the effect.<br />
Value: -63– +63<br />
CTRL Tone 1–4 (Tone Control Switch 1–4)<br />
Matrix Control Tone selects the tone to which the effect is<br />
applied when using the Matrix Control.<br />
Value<br />
OFF: The effect will not be applied.<br />
ON: The effect will be applied.<br />
REVS: The effect will be applied in reverse.