User's Manual ISO TNC 360 (260020xx, 280490xx) - heidenhain

2 Manual Operation and Setup
2.5 Setting the Datum with the 3D Touch Probe System
2-14
The following functions for setting the datum on an aligned workpiece are
listed for in the TCH PROBE menu:
• Datum setting in any axis with
SURFACE = DATUM
• Setting a corner as datum with
CORNER = DATUM
• Setting the datum at a circle center with
CIRCLE CENTER = DATUM
Setting the datum in a specific axis
Select the probe function SURFACE = DATUM.
Move the touch probe to a starting position near the touch point.
SURFACE = DATUM
X + X – Y + Y – Z + Z –
or
I
e.g. 0 ENT
Y
Z
1
Fig. 2.13: Probing for the datum in the Z axis
Select the probing direction and the axis in which you wish to set the datum,
for example Z in the Z– direction.
Probe the workpiece.
Enter the nominal coordinate of the DATUM.
X
TNC 360