User's Manual ISO TNC 360 (260020xx, 280490xx) - heidenhain

2 Manual Operation and Setup
2.5 Setting the Datum with the 3D Touch Probe System
2-16
DATUM Y =
.
.
.
e.g. 0 ENT
END
NO
ENT
Select the second coordinate.
Enter the second coordinate of the datum, for example in the Y axis.
Terminate the probe function.
If you do not wish to use points that were just probed for a basic rotation:
TOUCH POINTS OF BASIC ROTATION?
Probe both workpiece sides twice.
Enter the datum coordinates.
Ignore the dialog prompt.
TNC 360