User's Manual ISO TNC 360 (260020xx, 280490xx) - heidenhain
User's Manual ISO TNC 360 (260020xx, 280490xx) - heidenhain
User's Manual ISO TNC 360 (260020xx, 280490xx) - heidenhain
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4 Programming<br />
4.2 Tools<br />
Entering tool data in program 0<br />
4-8<br />
The data for all tools can be entered in a common tool table. The number<br />
of tools in the table is selected through the machine parameter MP 7260.<br />
If your machine uses an automatic tool changer, the tool data must be<br />
stored in the tool table.<br />
Editing the tool table (program 0)<br />
Abbreviation<br />
T<br />
S<br />
P<br />
L<br />
R<br />
PROGRAMMING AND EDITING<br />
PGM<br />
NR<br />
PROGRAM NUMBER =<br />
0 ENT<br />
Data in the tool table<br />
The tool table contains further information in<br />
addition to the tool dimensions.<br />
Call the program directory.<br />
Select the tool table.<br />
In the ELECTRONIC HANDWHEEL and MANUAL modes of operation, you can call the tool table at any time by<br />
simply pressing ENT.<br />
Input<br />
Fig. 4.3: Tool table<br />
Tool number: the number with which the tool is called in a<br />
part program<br />
Special tool with large radius requiring more than one<br />
pocket in the tool magazine. A certain number of pockets<br />
is kept vacant on each side of the special tool. The letter S<br />
then appears in front of the tool number.<br />
Pocket number of the tool in the magazine<br />
Compensation value for the Length of the tool<br />
Radius of the tool<br />
–<br />
Dialog<br />
SPECIAL TOOL?<br />
YES = ENT / NO = NO ENT<br />
POCKET NUMBER?<br />
TOOL LENGTH L?<br />
TOOL RADIUS R?<br />
<strong>TNC</strong> <strong>360</strong>
Change language