Quickstart manual - ICPDAS-EUROPE

Chapter 8
InduSoft Project Running In XPAC Access
To ISaGRAF Variables
Note:
If the HMI program behavior is slow or not smooth, please refer to Appendix F.
The XP-8xx7-CE6 is the abbreviation of the XP-8047-CE6/8347-CE6/8747-CE6.
The XP-8xx6-CE6 is the abbreviation of the XP-8046-CE6/8346-CE6/8746-CE6.
Important Notice:
1. Please always set a fixed IP address to the XP-8xx7-CE6/8xx6-CE6. (No
DHCP)
2. Recommend to use NS-205 or NS-208 Industrial Ethernet Switch for XPAC.
3. Please refer to XP-8xx7-CE6 CD-ROM:
\napdos\isagraf\xp-8xx7-ce6\english-manu\ "user_manual_i_8xx7.pdf” for
detailed ISaGRAF English User‟s Manual.
4. XP-8xx6-CE6 supports InduSoft and ISaGRAF logic running in the same
controller.
A simple example to run InduSoft & ISaGRAF logic in the same PAC:
Step 1: Create a new ISaGRAF project as below.
This demo uses a DI/O module I-87055W in slot 1 of XP-8xx6-CE6, and an AO
module I-87024W in slot 2 and one internal variable defined as follow.
Variable Type Name
Network
Address
Comment Attributes
Boolean DI_1 1 87055W DI channel 1 Input
Boolean DO_1 11 87055W DO channel 1 Output
Integer AO_1 21 87024W AO channel 1 Output
Integer Interior 31 Internal variable Internal
If you are not familiar with ISaGRAF, please refer to section 4.1 to 4.3.
And setup the I/O connection as following.
Getting Started : The XPAC-8xx7-CE6 PAC, Ver.1.23 , May 2012 by ICP DAS 8-1