Quickstart manual - ICPDAS-EUROPE

When you click on the "Link Setup" icon, the following window will appear.
Please set the proper value.
Net-ID of the XP-8xx7-CE6, default is 1.
COM port of your
PC
Click on it to set
other COMM‟s
parameter
COMM‟s parameter, default is
19200, N, 8, 1, No flow control
The RS-232 communication parameters for the target XP-8xx7-CE6 controller
MUST be set to the same serial communication parameters for the
development PC. For XP-8xx7-CE6 controllers (serial port communications),
the default parameters for COM2 (RS-232) port are:
Baudrate: 19200
Parity: none
Format: 8 bits, 1 stop
Flow control: none
(Please refer to Appendix A.2 to setup COM2 as Modbus RTU slave port)
DOWNLOADING THE EXAMPLE PROJECT
Before you can download the project to the controller, you must first verify that
your PC and the controller system are communicating with each other. To
verify proper communication, click on the "Debug" icon in the "ISaGRAF
Programs" window as shown below.
4-22 Getting Started : The XPAC-8xx7-CE6 PAC, Ver.1.23 , May 2012 by ICP DAS