Quickstart manual - ICPDAS-EUROPE

A.4 Connecting PC To The XP-8xx7-CE6 Ethernet Port
Before you can download an ISaGRAF application to the XP-8xx7-CE6 PAC
using the Ethernet port, you must first setup the Ethernet port to properly
communicate with the PC.
On the XP-8xx7-CE6 :
Set IP, Mask and Gateway address. Please refer to former section A.3.
On your PC:
First open an ISaGRAF project and select a program you wish to communicate
between your PC and the XP-8xx7-CE6 controller system.
Next, select the "Link Setup" button on the project screen as shown below.
Select the "Ethernet" communications option in the "PC-PLC Link Parameters"
dialog box and click on the "Setup" button.
An "Ethernet Link Parameters" dialog box will appear. Set the "Port Number"
to "502" and enter in the Internet address (IP) of the XP-8xx7-CE6 controller.
Then, click on the "OK" button.
Now you have configured your PC to communicate with the XP-8xx7-CE6
through the Ethernet port.
Ap-4
Getting Started : The XPAC-8xx7-CE6 PAC, Ver.1.23 , May 2012 by ICP DAS