Quickstart manual - ICPDAS-EUROPE

Please follow the same way to assign OUT01 to No.2, K1 to No.11, K2 to
No.12 and then Timer variable T1 to No.21. Then we have below window.
The Modbus Addr Numbers here
are always in hexidecimal format.
Very Important Notice:
If assign Modbus No. to Long integer or Float or Timer variables, they
should occupy two Modbus No. Please refer to XP-8xx7-CE6 CD-ROM:
\napdos\isagraf\xp-8xx7-ce6\english-manu\ "user_manual_i_8xx7.pdf” -
Section 4.2 for detailed information.
4.1.6 Create The LD - "LD1" Program
ISaGRAF will run every program one time in each PLC scan cycle. Programs
in the “begin” area will run first, then the “Sequential” area, and last the “End”
area. An ISaGRAF cycle runs in the way as the below scheme.
Scan all inputs
ISaGRAF
Cycle
Process „begin‟ area
Process „Sequential‟ area
Process „End‟ area
Refresh all outputs
Getting Started : The XPAC-8xx7-CE6 PAC, Ver.1.23 , May 2012 by ICP DAS 4-9