Quickstart manual - ICPDAS-EUROPE

A.7 Deleting the ISaGRAF Project From XP-8xx7-CE6
For some reasons, user may delete the ISaGRAF program in the XPAC.
1. Run “isaXPce6”
2. Click on “Setting” & then click on “Delete” of the “Current Application”.
Delete XP-8xx7-CE6's ISaGRAF program if some software damage
happens causing the WinCE software hanging:
1. Please turn the rotary switch to postion 1 (Safe mode) of the XPAC. Then
reset the XPAC-8xx7-CE6 again.
2. The XPAC will boot up as safe mode. Then get into the “My Device” on the
WinCE desktop. Please go to the “\System_Disk\isagraf\” directory, delete
file “ISA11”. The “ISA11” is the ISaGRAF current running application. (If you
can‟t find “ISA11” in that directory, please goto [Internet Explorer] > [View] >
[Internet Options] to modify the setting)
3. Turn the rotary switch to position 0 (Normal mode), then reboot XPAC.
When ISaGRAF is connected, it will display “No Application” .
4. When XPAC boots up in “Safe mode” and back to the “Normal mode”, user
needs to set up the IP setting of LAN1/LAN2 and other non-default setting
again. (Like the auto-execution of “isaXPce6.exe”)
Getting Started : The XPAC-8xx7-CE6 PAC, Ver.1.23 , May 2012 by ICP DAS Ap-7