Service Manual, General Motors 4.3L Engine (TP ... - Kohler Power

6-150 Marine/Industrial 4.3L Engine
5. Use the J 23523-F in order to press the crankshaft balancer
onto the crankshaft.
5.1. Install the J 23523-F plate and bolts onto the front of
the crankshaft balancer.
Tighten
Tighten the J 23523-F plate bolts to 25 N•m (18 lb ft).
5.2. Install the J 23523-F screw into the end for the
crankshaft.
5.3. Install the J 23523-F bearing, the washer and the nut
onto the J 23523-F screw.
5.4. Rotate the J 23523-F nut clockwise until the crankshaft
balancer hub is completely seated against the
crankshaft position sensor reluctor ring.
6. Remove the J 23523-F.
4065
Notice: Refer to Fastener Notice in Cautions and Notices.
7. Install the crankshaft pulley and bolts.
Tighten
Tighten the crankshaft pulley bolts to 58 N•m (43 lb ft).
188055
8. Ensure that the crown of the crankshaft balancer washer (2)
is faced away from the engine.
2000 Marine/Industrial
342203