Service Manual, General Motors 4.3L Engine (TP ... - Kohler Power
Service Manual, General Motors 4.3L Engine (TP ... - Kohler Power
Service Manual, General Motors 4.3L Engine (TP ... - Kohler Power
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Engine</strong> Marine/Industrial <strong>4.3L</strong> 6-169<br />
2. Install the exhaust manifold.<br />
3. Install the spark plug wire shields.<br />
Notice: Refer to Fastener Notice in Cautions and Notices.<br />
4. If reusing the fasteners, apply threadlock GM P/N 12345493<br />
or equivalent to the threads of the exhaust manifold bolts<br />
and stud.<br />
5. Install the exhaust manifold bolts and stud.<br />
Tighten<br />
5.1. Tighten the exhaust manifold bolts and stud on the first<br />
pass to 15 N•m (11 lb ft).<br />
5.2. Tighten the exhaust manifold bolts and stud on the final<br />
pass to 30 N•m (22 lb ft).<br />
6. Install the spark plug wires to the spark plug wire retainers.<br />
7. Install the spark plug wires onto the spark plugs.<br />
Clutch Pilot Bearing Installation<br />
Caution: Refer to Safety Glasses Caution in Cautions and<br />
Notices.<br />
1. Install the NEW clutch pilot bearing using a suitable clutch<br />
pilot bearing installation tool.<br />
2. Measure to ensure the proper installation depth is obtained.<br />
188121<br />
<strong>Engine</strong> Flywheel Installation<br />
Important: If replacing the engine flywheel (manual transmission),<br />
note the position of the original flywheel weights (if applicable).<br />
Flywheel weights must be installed into the new engine flywheel in<br />
the same location as the old flywheel weights were in the old<br />
engine flywheel.<br />
Note the position of the flywheel weights and install the NEW<br />
flywheel weights as required.<br />
A properly installed flywheel weight will be flush or slightly below<br />
flush with the face of the engine flywheel.<br />
334385<br />
64126<br />
2000 Marine/Industrial