Service Manual, General Motors 4.3L Engine (TP ... - Kohler Power
Service Manual, General Motors 4.3L Engine (TP ... - Kohler Power
Service Manual, General Motors 4.3L Engine (TP ... - Kohler Power
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Engine</strong> Marine/Industrial <strong>4.3L</strong> 6-35<br />
<strong>Engine</strong> Flywheel Removal<br />
1. Remove the engine flywheel bolts.<br />
2. Remove the engine flywheel (automatic transmission) (1), if<br />
applicable.<br />
3. Remove the engine flywheel (manual transmission) (2), if<br />
applicable.<br />
Important: If replacing the engine flywheel (manual transmission),<br />
then NEW flywheel weights must be installed into the NEW engine<br />
flywheel in the same location as the old flywheel weights in the old<br />
engine flywheel.<br />
Note the position of any flywheel weights for assembly (if<br />
applicable).<br />
188129<br />
Clutch Pilot Bearing Removal<br />
Tools Required<br />
J 43276 Clutch Pilot Bearing Remover<br />
Caution: Refer to Safety Glasses Caution in Cautions and<br />
Notices<br />
Notice: When using the J 43276 Clutch Pilot Bearing Remover,<br />
always secure the J 43276-1 Clutch Pilot Bearing Remover tool<br />
body using a wrench. Do not allow the J 43276-1 Clutch Pilot<br />
Bearing Remover tool body to rotate. Failing to do so will cause<br />
damage to the J 43276-1 Clutch Pilot Bearing Remover tool body.<br />
1. Remove the clutch pilot bearing using the J 43276<br />
1.1. Install the J 43276 tool body into the clutch pilot<br />
bearing.<br />
64126<br />
353275<br />
2000 Marine/Industrial