SENTROL Application notes - Alarms BC
SENTROL Application notes - Alarms BC
SENTROL Application notes - Alarms BC
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
.........................................................................................................................................................................<br />
Residential & Commercial <strong>Application</strong>s<br />
PROTECTING ANDERSON CASEMENT WINDOWS<br />
APPLICATION 1<br />
INSTALLATION<br />
RECOMMENDED<br />
PRODUCTS<br />
Surface Mount Contacts<br />
Using surface mount contacts, the switch and magnet are both concealed when the<br />
window is closed. Use off-white, white or mahogany brown units to match plastic<br />
cover on the window.<br />
Important: Anderson recommends against mounting switches in sills due to<br />
possible damage from water. If you must drill into the sill, make sure you provide a<br />
solid, tight seal using RTV compound.<br />
Select position of switch and magnet. Ventilation may be achieved with the use of<br />
a wide gap switch placed on the top of the window near the hinged side.<br />
Drill hole for wires. Slant back 15˚ to 30˚ to make sure wires go inside wall. Drill at<br />
back of window frame as shown.<br />
Clean surfaces with alcohol to remove dirt, grease and moisture.<br />
Peel paper from back of switch and install as shown, or screw in place (depending<br />
on switch used).<br />
Peel paper from back of magnet. Install on sash frame with Sentrol name reading<br />
the same direction as on switch.<br />
Close window and test circuit.<br />
1125, 1035, RTV 1905<br />
Switch<br />
Magnet<br />
Wire access hole.<br />
Drill at 15°–30° from<br />
vertical.<br />
MAGNETIC CONTACTS<br />
Figure 1. (Top of Window)<br />
Magnet<br />
Switch<br />
Wire access<br />
hole.<br />
Drill at 15°–30°<br />
from vertical.<br />
Figure 2 (Bottom of Window)<br />
3.33
Change language