SENTROL Application notes - Alarms BC
SENTROL Application notes - Alarms BC
SENTROL Application notes - Alarms BC
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
.........................................................................................................................................................................<br />
Commercial <strong>Application</strong>s<br />
SILENT PANIC SWITCH FOR WALK-IN FREEZERS<br />
APPLICATION<br />
INSTALLATION<br />
RECOMMENDED<br />
PRODUCTS<br />
Installing a silent panic switch in a walk-in freezer to prevent accidental lockup or<br />
intentional imprisonment of a person inside a walk-in freezer. The Sentrol<br />
3040CT, 3045CT, 3050CT and 3055CT have been specifically modified for lowtemperature<br />
use in walk-in freezers. The 3050CT and 3055CT feature a glowing<br />
LED for low light visibility. The LED glows green when powered up, turns red<br />
upon activation. The 3050CT contains a latching LED, the 3055CT is<br />
non-latching.<br />
The best location for the freezer switch is mounted inside the freezer, at some<br />
point between the floor and 4" (10.2 cm) below the door knob. The switch should<br />
be able to be reached by someone lying on the floor.<br />
Temporarily position the 3040CT or 3045CT where it will be mounted and mark<br />
the screw holes and the hole for the leads. Drill pilot holes or start the screws.<br />
Insert the screws through the switch housing and tighten firmly in place.<br />
Note: The 3040CT has a separate latching LED circuit. It must be powered and<br />
reset by a push-button +5 to 12 VDC source in or mounted outside the alarm<br />
panel. The 3045CT has no latching LED.<br />
Test the 3040CT by pulling the handle down until the LED lights. Close the<br />
handle. Activate the normally closed push-button or toggle switch located in<br />
the master control panel to interrupt power to the latching LED. The LED will<br />
go out.<br />
Test the 3045CT by pulling the handle down.<br />
3040CT, 3045CT, 3050CT, 3055CT<br />
MAGNETIC CONTACTS<br />
3.74