26.11.2014 Views

MPED-X-Routing-Tender20080721 - Madhya Pradesh State Excise

MPED-X-Routing-Tender20080721 - Madhya Pradesh State Excise

MPED-X-Routing-Tender20080721 - Madhya Pradesh State Excise

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Miscellaneous<br />

All necessary power cords, adapters, data cables, connectors, CDs,<br />

manuals, brackets accessories, wire managers, etc. should be provided<br />

4.23a) G.703 & V.35 lease line modems 2 Mbps for DC<br />

4.23b) G.703 & V.35 lease line modems to support 256 Kbps for Remote Locations<br />

Compliance<br />

Description<br />

According to ETSI HDSL / G.SHDSL to ITU T G991.2 Standard<br />

Mode of<br />

operation<br />

Selectable Data<br />

Rate<br />

Management<br />

Features<br />

Interface<br />

Leased – Unconditioned copper 2 / 4 Wire<br />

N*64 Kbps up to 2048 Kbps (Synchronous)<br />

Standalone to Standalone Management through 10/100 base TX out of band<br />

management port, Internal BERT option for diagnostics, Telnet & Web browser for<br />

configuration and diagnostics, Dipswitches for loop back, Line protection circuits<br />

against lightning and power surges and follow ITU K.21 and UL 1950 standards.<br />

DCE interface G.703, DTE interface V.35.<br />

Opearting Range Should support to 10KM for 64 KBPS and 5 KM for 2048 KPBS over 24 AWG<br />

(0.5mm) or higher<br />

Cables<br />

Power Supply<br />

Indicators<br />

Architecture<br />

Approval<br />

All necessary cables including power cord<br />

Inbuilt support to work in both 230V 50 Hz AC and -48VDC from a single socket and<br />

not to be an ordering option<br />

Power, Test, Alarm/Loss, Sync<br />

Stand alone unit<br />

Should be TEC approved.<br />

4.24 a) Central Internet Router<br />

Router / Modules having following features / facilities<br />

• Should have atleast 4 interface card slots<br />

• Should have atleast 1 Network Module Slot<br />

• Should have minimum 2 numbers of Serial Ports having support for 2 Mbps/ port<br />

Bandwidth with necessary cables<br />

• At least 2 Numbers of on-board Gigabit Ethernet (10/100/1000) interfaces.<br />

• The architecture should be based on high speed CPU.<br />

• Support for Hot Standby Router Redundancy/VRRP, GLBP protocol<br />

• The router should have a minimum of 200,000 pps throughput.<br />

• Support for low speed sync/async interfaces.<br />

• Bandwidth Optimization:<br />

i. Dial-Backup<br />

ii. Dial-on-Demand<br />

iii. Bandwidth on Demand<br />

iv. Header and payload Compression Inactivity timeouts<br />

• Support for Webvpn<br />

• Should support below IP <strong>Routing</strong> Protocols:<br />

i. RIP<br />

78

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!