MPED-X-Routing-Tender20080721 - Madhya Pradesh State Excise

i. The architecture should be based on high speed CPU.
ii. The Router should be a Single Box configuration and modular, so that the purchaser
has the flexibility to use the appropriate choice of interfaces as and when required.
B. High Availability Requirements
i. Support for Hot Standby Router Redundancy Protocol.
ii. The software on the router must have online software reconfiguration to ensure that
changes made to a router configuration take place with immediate effect.
iii. It must be possible to fast boot the router to ensure that for software upgrades can be
done with minimum network downtime.
iv. High Mean Time between Failure values should be available to ensure long life of router
hardware.
v. The router should be capable of booting from a remote node, where the router image is
present.
C. Miscellaneous Hardware Requirements
i. Should have 2 onboard 10/100 BaseT Interfaces and atleast 2 WAN Interface Slots.
ii. Should have atleast 1 serial port with support up to 2 Mbps bandwidth and necessary
cables.
iii. Should support for ISDN BRI port (as and when required)
iv. Router must have 32 MB Flash upgradeable to 128 MB
v. Router must have 128 MB DRAM upgradeable to 384 MB
vi. Extensive debugging capabilities to assist in hardware problem resolution.
D. Performance Requirements
i. The router should have a minimum of 70,000 pps throughput.
E. Router Software Features.
i. Shall support (when required by an software upgrade) IPSec, 3DES,AES Encryption;
the IPSec implementation should be IETF compliant
ii. Should support Intrusion Prevention Functionality (when required by an software
upgrade)
Other General Specifications:
1. Router OS should have features of below IP Routing Protocols:
i. RIPv1 & v2
ii. OSPF
iii. OSPF Over Demand Circuits
2. Network Address Translation (NAT) should be available in the delivered
configuration.
3. WAN Protocols:
i. PPP
ii. Multilink PPP
iii. X.25
iv. Frame Relay
v. Compression-Payload and TCP/IP Header
4. Multicasting
81