Driver Installation Guide - Egmont Instruments
Driver Installation Guide - Egmont Instruments
Driver Installation Guide - Egmont Instruments
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 3 - Verifying Signal<br />
Acquisition<br />
Verifying Signal Acquisition with CS_TEST<br />
for Windows 95/98/NT/2000<br />
CS_TEST.EXE is a utility program which allows acquisition<br />
and display of data from a CompuScope board. It acts as a<br />
test to ensure that your CompuScope board(s) is fully<br />
functional.<br />
Now that you have successfully installed the CompuScope<br />
<strong>Driver</strong>s and have tested driver installation with the Gage<br />
Config utility, you can run CS_TEST to verify that these drivers<br />
are properly communicating with the CompuScope card(s).<br />
Setting up your Hardware<br />
Using a function (signal) generator, generate a 1 MHz sine<br />
wave signal and connect it to the CH1 input of your<br />
CompuScope card. If you have installed a CompuScope 8500<br />
board, use the 1MΩ input instead.<br />
Verifying Signal Acquisition / CS_Test 137