Driver Installation Guide - Egmont Instruments

Installing GageScope ® for DOS
Insert the Gage Driver Disk CD in your CD-ROM Drive. This
will initiate the AutoRun feature on the CD, which will launch
the Gage Driver Disk Setup program.
If the Gage Driver Disk Setup program does not AutoRun,
please refer to Starting the Gage Driver Disk Setup program
earlier in this guide.
Once the setup program has completed loading, the following
window will be displayed:
Note: The GageScope ® for DOS option is only available when
installing CompuScope Drivers under Windows 95 or 98;
GageScope ® for DOS cannot be installed on a system running
Windows NT.
Highlight and click the GageScope ® for DOS option from the
upper window. Your selection will now appear in the bottom
window.
Installation / GageScope for DOS 67