Driver Installation Guide - Egmont Instruments
Driver Installation Guide - Egmont Instruments
Driver Installation Guide - Egmont Instruments
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Memory Base Addresses Specified in Gage Config<br />
If the Board Name field displays your board name, for<br />
example CS2125, but the Memory Size reads N/A, you have<br />
a memory conflict. You may need to change the memory base<br />
address(es) in Gage Config.<br />
Ensure that you do not specify an address you are using or will<br />
be using for another board; each CompuScope board must<br />
have its own memory base address.<br />
Note: There are no jumpers or DIP switches to select the<br />
memory address; it is done in software.<br />
Changing the Memory Base Address in Gage Config<br />
Upon starting Gage Config for the first time, the Memory Base<br />
field shows the default Memory Base Address for each of your<br />
CompuScope boards. If there is no memory conflict between<br />
the default settings and your PC, then you do not have to edit<br />
this field. The default memory base address for a single<br />
CompuScope board is D000. For Multi-Card systems, the<br />
Memory Base addresses are listed on a sheet enclosed with<br />
your boards.<br />
To change the Memory Base Address in Gage Config, doubleclick<br />
on the Memory Base field and you will see the Board<br />
Location dialog.<br />
88<br />
<strong>Driver</strong> <strong>Installation</strong> <strong>Guide</strong> for CompuScope Cards
Change language