Driver Installation Guide - Egmont Instruments

Change the frequency of the signal source to determine that
new data is being captured by CS_TEST. As you change the
frequency, you should see a corresponding change in the sine
wave being displayed.
Note: You may have noticed the eight-digit number in the
bottom left corner of the CS_TEST window. This is a counter.
Every time CS_TEST acquires data, the counter is
incremented by 1.
Now, go back to the Controls menu and click on Abort. This
will stop any further acquisition.
We will now change a trigger parameter such as Trigger Slope
to verify that all controls for the board are working as they
should. Go to the Parameters menu and select Trigger
Control.
You should see a new dialog box.
Verifying Signal Acquisition / CS_TEST 141