MICROMASTER 440 - Siemens AS
MICROMASTER 440 - Siemens AS
MICROMASTER 440 - Siemens AS
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Issue 10/06<br />
7 Displays and messages<br />
7.2 Fault messages and Alarm messages<br />
Fault Significance Alarm Significance<br />
F0001 Overcurrent A0501 Current Limit<br />
F0002 Overvoltage A0502 Overvoltage limit<br />
F0003 Undervoltage A0503 Undervoltage Limit<br />
F0004 Inverter Overtemperature A0504 Inverter Overtemperature<br />
F0005 Inverter I 2 t A0505 Inverter I 2 t<br />
F0011 Motor Overtemperature I 2 t A0506 Inverter Duty Cycle<br />
F0012 Inverter temp. signal lost A0511 Motor Overtemperature I 2 t<br />
F0015 Motor temperature signal lost A0520 Rectifier Overtemperature<br />
F0020 Mains Phase Missing A0521 Ambient Overtemperature<br />
F0021 Earth fault A0522 I2C read out timeout<br />
F0022 HW monitoring active A0523 Output fault<br />
F0023 Output fault A0535 Braking Resistor Hot<br />
F0024 Rectifier Over Temperature A0541 Motor Data Identification Active<br />
F0030 Fan has failed A0542 Speed Control Optimization Active<br />
F0035 Auto restart after n A0590 Encoder feedback loss warning<br />
F0040 Automatic Calibration Failure A0600 RTOS Overrun Warning<br />
F0041 Motor Data Identification Failure A0700 - CB warning 1<br />
F0042<br />
Speed Control Optimization Failure<br />
F0051 Parameter EEPROM Fault A0709 CB warning 9<br />
F0052 Power stack Fault A0710 CB communication error<br />
F0053 IO EEPROM Fault A0711 CB configuration error<br />
F0054 Wrong IO Board A0910 Vdc-max controller de-activated<br />
F0060 Asic Timeout A0911 Vdc-max controller active<br />
F0070 CB setpoint fault A0912 Vdc-min controller active<br />
F0071 USS (BOP link) setpoint fault A0920 ADC parameters not set properly<br />
F0072 USS (COM link) setpoint fault A0921 DAC parameters not set properly<br />
F0080 ADC lost input signal A0922 No load applied to inverter<br />
F0085 External Fault A0923 Both JOG Left and Right are requested<br />
F0090 Encoder feedback loss A0952 Belt Failure Detected<br />
F0101 Stack Overflow A0936 PID Autotuning Active<br />
F0221<br />
F0222<br />
F0450<br />
F0452<br />
PID Feedback below min. value<br />
PID Feedback above max. value<br />
BIST Tests Failure<br />
(Service mode only)<br />
Belt Failure Detected<br />
...<br />
...<br />
<strong>MICROM<strong>AS</strong>TER</strong> <strong>440</strong><br />
Operating Instructions (Compact) 77
Change language