Manual - Gefen

Operating the 8x8 Crosspoint Matrix for HDMI
Using the IR Remote Control
Routing Sources using the IR Remote Control
The included IR Remote Control unit provides discrete routing between each input and
output.The IR remote control unit consists of 16 buttons. Each button represents an
input / output.
Let’s look at an example: Route Input 5 to Output C
1. Point the IR remote control at the IR sensor on the front panel of the matrix.
2. First, select the output by pressing button C on the IR remote control unit. The LED
on the IR remote control unit will glow bright yellow to indicate that a button was
pressed.
LED indicates a
button was pressed
Press button C
OUT:ABCDEFGH
IN:12335678
C
IR sensor
The front-panel LCD will display the selected output:
OUT:ABCDEFGH
IN:12335678
C
3. Next, press the desired input. In this example, we want to route Input 5 to Output C.
Therefore, press button 5 on the IR remote control unit.
(continued on next page)
page | 23