Manual - Gefen
Manual - Gefen
Manual - Gefen
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Advanced Operation<br />
RS-232 / IP Commands<br />
#show_r<br />
The #show_r command displays the routing status of the specified output.<br />
Syntax:<br />
#show_r param1<br />
Parameters:<br />
param1 Output [A ... H]<br />
Example:<br />
#show_r d<br />
OUTPUT D(Dell_30) IS ROUTED TO INPUT 5(Blu-ray)<br />
r<br />
The r command routes the specified input to the specified outputs. Up to eight outputs can<br />
be specified at a time. Do not precede this command with the “#” symbol. If param2 = 0,<br />
then the specified input will be routed to all outputs. Also see the s command on the next<br />
page.<br />
Syntax:<br />
r param1 param2 [... param9]<br />
Parameters:<br />
param1 Input [1 ... 8]<br />
param2 Output [A ... H]<br />
Example:<br />
r 1 c d h<br />
INPUT 1 IS SET TO OUTPUTS C, D, H<br />
r 1 0<br />
INPUT 1 IS SET TO ALL OUTPUTS.<br />
page | 52
Change language