Op Amps for Everyone - The Repeater Builder's Technical ...

S
Sallen-Key band-pass filter, circuit, 16-30
Sallen-Key high-pass filter
biasing circuit, 16-50
circuit, 16-24
circuit with unity gain, 16-24
Sallen-Key low-pass filter
biasing circuit, 16-48
circuit, 16-15
circuit with unity gain, 16-15, 16-20
Sallen-Key topology, 16-14 to 16-18, 16-24 to 16-26
band-pass filter, 16-30 to 16-32
Saturated transistor circuit, 2-9 to 2-11
Schematic, 6-5
simultaneous equation, 4-9, 4-13, 4-16, 4-19
Second order equation, 5-15 to 5-17
Second-order all-pass filter, 16-44 to 16-46
Second-order band-pass filter, 16-29 to 16-33
multiple feedback topology, 16-31 to 16-33
Sallen-Key topology, 16-30 to 16-32
Second-order high-pass filter, 16-24 to 16-27
multiple feedback topology, 16-25 to 16-27
Sallen-Key topology, 16-24 to 16-26
Second-order low-pass filter, 16-14 to 16-20
coefficients, 16-17
multiple feedback topology, 16-18 to 16-20
Sallen-Key topology, 16-14 to 16-18
Self resonance, capacitor, 17-22
Settling time, 11-22
DAC, 14-16 to 14-18
graph, 11-22
Shot noise, 10-5 to 10-8
Shutdown, op amp, 18-12 to 18-14
Sigma-delta, DAC, 14-5 to 14-7
Signal conditioning, for IF sampling, 13-1 to 13-23
Signal-to-noise and distortion, DAC, 14-14
Signal-to-noise ratio, 10-3
op amp, 18-5 to 18-7
Significant bits, versus binary bits, 12-2
Simultaneous equations, 4-8 to 4-19
SINAD, DAC, 14-14
Sine wave oscillator, 15-1 to 15-21
circuits, 15-9 to 15-21
description, 15-1
Single supply op amp, 4-1 to 4-23
circuit, 4-1
inverting circuit, 4-4, 4-5
circuit analysis, 4-3 to 4-8
inverting, 4-3 to 4-6
noninverting, 4-6 to 4-8
noninverting circuit, 4-7
transfer curve, 4-5, 4-7
vs dual supply, 4-1 to 4-4
Single-ended, to diff output drive circuit, 13-18
Single-ended input drive, circuit for ADC, 13-20
Single-supply circuit design, 18-13
Single-supply filter, circuit, 16-47
Single-supply operation, DAC, 14-22 to 14-24
Slew rate
at unity gain, 11-16
circuit, 11-16
Slot antenna, PCB layout, 17-15
SNR. See signal-to-noise ratio
Spans, requiring correction, 12-4
Spectral density, graph, 13-14
Split-supply op amp, circuit, 10-19
Spot noise, 11-17 to 11-19
Spurious free dynamic range, DAC, 14-15
Stability
current feedback amp, 8-11 to 8-13, 9-6 to 9-8
feedback capacitance, 8-12 to 8-14
op amp loading capacitance, 7-4
voltage feedback amp, 9-6 to 9-8
Stability analysis
circuit, 8-2, 8-3
current feedback amp, 8-7 to 8-10
Stability equation, 8-2 to 8-4
Stray capacitance
graph for current feedback amp, 8-12
on inverting input circuit, 7-16
Summary points, block diagram math, 5-3
Superposition, 2-8 to 2-10
Supply current, 11-16
Supply voltage rejection ratio, 11-15
System specifications, review, 12-12
T
T network circuit
feedback loop, 3-7
Thevenim’s theorem, 3-8
Termination, unused op amps, 17-28
Index-12