Star-Hspice Quick Reference Guide

Junction Cap Model
nodeplus
nminus
mname
area
peri
pgate
off
M
ic
Dtemp
Positive terminal (anode) node name. The
series resistor of the equivalent circuit is
attached to this terminal
Negative terminal (cathode) node name
Diode model name reference
Diode area. In the model card, it can be
used by AB
Length of the side-wall of the diffusion area
AB which is not under the gate. In the
model card, it is used by LS
Length of the side-wall of the diffusion area
AB which is under the gate. In the model
card, it is used by LG
Sets initial condition to OFF for this
element in DC analysis. The default is ON
Multiplier to simulate multiple diodes in
parallel. All currents, capacitances and
resistances are affected by setting M.
Default=1
Initial voltage across the diode element.
This value is used when the UIC option is
present in the .tran statement and is
overriden by the .ic statement
The difference between the element
temperature and circuit temperature in
celsius. Default=0.0
Star-Hspice Quick Reference Guide 6-7