User Guide Product(range) - Neopost

More documents

Recommendations

Info

Pos: 60.86 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_3235_Prewarming @ 1\mod_1255684370577_912.doc @ 6659 @ Pos: 60.87 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_3236_PEN Board @ 1\mod_1255684373658_912.doc @ 6663 @ Pos: 60.88 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_3241_LED/ Beeper @ 0\mod_1254916802136_912.doc @ 5103 @ Cartridges This test checks the electronically connections between cartridge mountings and printheads. The results of the test are shown in the display. Test HP PEN ID MISSING DOTS Note The identification code of each PEN board (e. g 13 = Unit U1, Cartridge C3). Number of missing dots of the cartridges, that can’t be controlled by the printer. If all nozzles response correctly, the display will show “no”. Amount of missing dots The amount of missing dots (MISSING DOTS) can be an evidence, that the connection between printhead and cartridge mounting is interfered. If the amount of missing dots is a multiple of seven (14, 21, 28, ...), the problem lies most likely in a draggled printhead contacting. In this case, clean the contacts of the printhead and that of the cartridge mounting with a piece of cloth, an repeat the test. Prewarming The Prewarming function of the printer will be checked in this test. Afterwards the printer should display the “PREWARMING:o Data/s” status. PEN Board This test will check the circuit (PEN) boards that are integrated in the print units. The test will be performed with all circuit boards of the printer. Authorised service personal can use the values of this test for service purposes. Test AMB.TEMP REF.RES[h] TSR [Hex] Note The measured temperature close to the printhead nozzles in degree Celsius °C “Reference Resistor” – reference value „Thermal Sense Resistor“ - resistance value inside the printhead 66 <strong>User</strong> Manual Version 3.1
LED/Beeper Here you can check if all the LEDs of the display and the beeper work correctly. When performing this test the printer will run through the following cycle: ALL LED's OFF LED ONLINE ON LED OFFLINE ON LED WARNING ON LED ERROR ON BEEPER ON (you will hear a sound for two seconds) Pos: 60.89 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü2/Ü2_3300_CONFIGURAT._INFO @ 0\mod_1254837071173_912.doc @ 4621 @ <strong>User</strong> Manual Version 3.1 67
Page 1 and 2:
as-930 aDDress PrInTer User ManUal
Page 3 and 4:
Pos: 3 /[Allgemeines]/0.0a_Note_Tra
Page 5 and 6:
6 Printer menu (firmware V4.8).....
Page 7 and 8:
Table of Figures Figure 1:AS-930 Ov
Page 9 and 10:
Pos: 8 /Bedienungsanleitungen/Gerä
Page 11 and 12:
Pos: 13 /Bedienungsanleitungen/Ger
Page 13 and 14:
Page 15 and 16: Pos: 28 /Bedienungsanleitungen/Ger
Page 23 and 24: 2: Ink costs and ink range This lin
Page 29 and 30: fixing screws lift those separation
Page 33 and 34: wing screw print area Figure 14: Po
Page 39 and 40: JOB PARAMETERS.....................
Page 41 and 42: Pos: 60.3 /Bedienungsanleitungen/Ge
Page 45 and 46: MAIN MENU The Home key opens the ma
Page 47 and 48: KEEP ALIVE Here you can turn on the
Page 49 and 50: Pos: 60.23 /Bedienungsanleitungen/G
Page 65: Pos: 60.79 /Bedienungsanleitungen/G
Page 71 and 72: Pos: 60.109 /Bedienungsanleitungen/
Page 81 and 82: 2. Connect the PC to the printer
Page 85 and 86: Correct IP address syntax Don’t e
Page 87 and 88: 7.4.3 Using a fixed IP address 1. P
Page 117 and 118:
Pos: 81.8 /Bedienungsanleitungen/Ge
Page 119 and 120:
Pos: 81.16 /Bedienungsanleitungen/G
Page 121 and 122:
Page 123 and 124:
Pos: 83.12 /Bedienungsanleitungen/G
Page 125 and 126:
Pos: 85 /Serviceanleitungen/Geräte
Page 127 and 128:
Pos: 90 /Zubehör/Generelles Zubeh
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
11.4 How to test the Ethernet conne
Page 139 and 140:
11.5 Network connection between the
Page 141 and 142:
Page 143 and 144:
11.7 How to create a print file Dep
Page 145 and 146:
Pos: 100 /Serviceanleitungen/Gerät
Page 147 and 148:
4 • Enable “Send to printer”
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
12 Glossary Term Addressing ASCll B
Page 155 and 156:
Font inclination Font type HP TIJ 2
Page 157 and 158:
Printer Driver Printhead Printhead
Page 159 and 160:
13 Index Accessories ..............
Page 161:
9204019U-B edition 08/04/2011 - 920
show all

User Guide Product(range) - Neopost

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?