2 - ClamSITel
2 - ClamSITel
2 - ClamSITel
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Best COMPLETE Pushrod<br />
System we’ve seen!<br />
HLFK0624 Kavan Complete Airplane Pushrod Set, 2 ............ $8.79<br />
Two 36” long complete pushrods that use tiny 1/32” music wire inside<br />
special slippery plastic tube, which is inside a larger plastic tube. The outside<br />
tube is only 1/8” diameter. Included are 4 very fine threaded couplers<br />
and two of these threaded couplers come already attached to the<br />
pushrod ends. Solder or crimp the other 2 threaded couplers to the inner<br />
pushrods and screw on the quality Kavan metal clevises (4 included.)<br />
Specialty Control Horns<br />
Precision turnbuckles<br />
HLFK3050 7/8” Brass Turnbuckles, pair ......................................... $8.89<br />
HLFK3052 2” Brass Turnbuckles, pair ........................................ $11.99<br />
Solid Brass Turnbuckles<br />
GR5711 Graupner<br />
5/8” Turnbuckles, 10 ............................. $23.99<br />
GR5712 Graupner<br />
1” Turnbuckles, 10 ................................. $28.99<br />
Protect your plane’s<br />
finish. These mount<br />
either with screws or<br />
by gluing the shafts<br />
into holes.<br />
RA1350 Mini Skids, 2 .......................................................................... $1.09<br />
RA1355 Large Skid .............................................................................. $1.09<br />
Minis are 1-1/4” long overall. Large skid is 2” long overall.<br />
Hinge Tape<br />
Foam Rubber Receiver Protection<br />
This foam protects your receiver<br />
RUF001 Foam Rubber,<br />
1/2x8x12" .......................................... $6.89<br />
A sheet of latex foam rubber -the best. Cut<br />
to size and wrap your receiver. Secure with<br />
rubber bands or masking tape.<br />
Hardware, Tools and Miscellaneous<br />
Odd control horns<br />
GR10119 Rudder Horns for V-Tails, pair ........................................ $4.89<br />
7/8" long horns that extend 110 (degrees) from the control surface instead<br />
of the usual 90 (degrees).<br />
GR1133 Elevator Horn for T-Tails .................................................. $4.69<br />
1-1/8" long horn used for elevators on T-Tail airplanes where the elevator<br />
pushrod runs vertically up inside or along the vertical fin. The long length<br />
reduces elevator throw in elevator-sensitive T-Tails.<br />
GR3668 Shaft-mount Aileron Horns, pair ...................................... $2.49<br />
Horn portion is about 5/8" long. Insert shaft through hole. Glue in place.<br />
Cut off the shaft. Scale appearance.<br />
Tape for control surface hinges.<br />
GR8694 Clear Hinge Tape, 32 feet ......................... $5.89<br />
3/4” wide. The particular plastic used is flexible, non-tearable,<br />
and ideally suited for control surface hinges. The adhesive adheres well to<br />
any smooth surface. Ideal for aileron hinges on sailplanes where they permit<br />
no airflow through the hinge line to spoil the intent of the airfoil. Can be<br />
used for all control surfaces.<br />
Hatch Latches<br />
Hatch Latch<br />
installs in single drilled hole<br />
GR8066 Graupner<br />
Brass-Steel Hatch Latch ............. $3.99<br />
Spring loaded steel pin in a brass housing makes a perfect latch for cabins,<br />
cowls, etc. About an inch long. Installs simply into 3/16” hole.<br />
Strongest hatch latch is<br />
easiest to mount<br />
HLRE001 Best Hatch Latch ........ $4.99<br />
1-7/8” long overall. “Best” because the<br />
body is very strong plastic, and it is very<br />
easy to mount using 4 small screws.<br />
Tiny hatch latch<br />
GR426012 Smallest<br />
Hatch Latch ........................... $5.79<br />
1” x 3/8” x 3/16”. Plastic, glue in place<br />
with UHU glue or Stabilit Express.<br />
Unassembled. Weight about 2 grams.<br />
Ideal for Speed 400 airplanes.<br />
MJ2660 Lightweight<br />
Plastic Hatch Latch<br />
........................ $2.29<br />
5/16” wide, 7/8” long.<br />
The same latch that is<br />
in our P-51 and P-47.<br />
Glue it in place.<br />
Weighs less than 1/2 gram<br />
Rare Earth Magnets hold<br />
Canopies and Hatches Firm!<br />
Neodymium magnets are perfect for<br />
securing hatches. These are very strong<br />
and allow you to make a working hatch<br />
with no release mechanisms protruding<br />
outside of the model. Each package<br />
contains 4 neodymium disc magnets and<br />
4 flat washers.<br />
DMAG136 1/8” x 1/16” Neodymium Disc Magnets, 4 ............. $3.39<br />
DMAG127 1/8” x 1/8” Neodymium Disc Magnets, 4 .............. $3.39<br />
DMAG308 3/16” x 1/16” Neodymium Disc Magnets, 4 .......... $3.39<br />
DMAG101 1/4” x 1/8” Neodymium Disc Magnets, 4 .............. $3.39<br />
DMAG248 3/8” x 1/16” Neodymium Disc Magnets, 4 ............ $3.39<br />
Airplane Storage<br />
A secure way to<br />
store any size<br />
model airplane<br />
Use the Wall Hanger for<br />
storing fuselages (with<br />
or without the wings).<br />
The Ceiling Hangers<br />
store airplanes with the<br />
wing attached. The dimension<br />
given is<br />
approximate and is the length of the horizontal bars. The vertical portion<br />
is about the same length. Hangers are made of 1/4” diameter<br />
steel with foam sleeves so they won’t dent balsa. The best recommendation<br />
we can give them is that we store all of our airplanes on<br />
them.<br />
BIG007 Wall Hanger 7” ............................................................ $24.99<br />
BIG013 Ceiling Hanger 13” ..................................................... $24.99<br />
BIG015 Ceiling Hanger 15” ..................................................... $26.99<br />
BIG018 Ceiling Hanger 18” ..................................................... $29.99<br />
www.hobby-lobby.com • Order Online 24/7 99