FortiGate Administration Guide - FirewallShop.com

FortiWiFi-50B, 60A, 60AM, and 60B system wireless settings
System Wireless
Table 7: IEEE 802.11g (2.4-GHz Band) channel numbers
Regulatory Areas
Channel Frequency
Americas EMEA Israel Japan
number (MHz) CCK ODFM CCK ODFM CCK ODFM CCK ODFM
1 2412 X X X X – – X X
2 2417 X X X X – – X X
3 2422 X X X X – – X X
4 2427 X X X X – – X X
5 2432 X X X X X X X X
6 2437 X X X X X X X X
7 2442 X X X X X X X X
8 2447 X X X X X X X X
9 2452 X X X X – – X X
10 2457 X X X X – – X X
11 2462 X X X X – – X X
12 2467 – – X X – – X X
13 2472 – – X X – – X X
14 2484 – – – – – – X –
FortiWiFi-50B, 60A, 60AM, and 60B system wireless settings
Go to System > Wireless > Settings to configure wireless settings. You can
configure wireless settings for the FortiWiFi-50B, 60A, 60AM, 60B unit and for the
wireless interfaces added to the unit. Most wireless configuration settings are only
available in access point mode.
The default wireless configuration includes one wireless interface, called wlan. If
you are operating your FortiWiFi unit in access point mode, you can add up to
three more wireless interfaces (for a total of 4) using the procedure described in
“Adding a wireless interface to a FortiWiFi-50B, 60A, 60AM, and 60B unit” on
page 122.
Note: All wireless interfaces have the same wireless parameters. This means that all
wireless interfaces have the same setting for band, geography, channel, Tx power, and
beacon interval.
Figure 61 shows a sample FortiWiFi-50B wireless configuration that includes
three wireless interfaces (wlan-vlan2, wlan-vlan3, and wlan-vlan4) added to the
wlan interface using the procedure “Adding a wireless interface to a FortiWiFi-
50B, 60A, 60AM, and 60B unit” on page 122.
FortiGate Version 3.0 MR5 Administration Guide
120 01-30005-0203-20070830