FortiGate Administration Guide - FirewallShop.com

System Wireless
Wireless Monitor
MAC Filter Enable
Access for PCs not
listed below
MAC Address
Allow or Deny
Add
Allow List
Deny List
Arrow buttons
Remove (below
Allow list)
Remove (below
Deny list)
Enable the MAC Filter.
Select whether to allow or deny access to unlisted MAC addresses.
Enter the MAC address to filter.
Select whether to allow or deny the MAC Address.
Add the MAC address to the Allow or Deny list, as selected.
List of MAC addresses allowed access to the wireless network.
List of MAC addresses denied access to the wireless network.
Move MAC addresses between lists.
Remove selected MAC addresses from Allow list.
Remove selected MAC addresses from Deny list.
Wireless Monitor
Go to System > Wireless > Monitor to see who is connected to your wireless
LAN. This feature is available only if you are operating the wireless interface in
WPA security mode.
Figure 68: FortiWiFi-50B, 60A, 60AM, and 60B wireless monitor
Figure 69: FortiWiFi-60 wireless monitor
Statistics
AP Name
Frequency
Signal Strength (dBm)
Noise (dBm)
S/N (dB)
Statistical information about wireless performance for each
wireless interface. Statistics are available for
FortiWiFi-50B, 60A, 60AM, and 60B units.
The name of the wireless interface.
The frequency that the wireless interface is operating with.
Should be around 5-GHz for 802.11a interfaces and
around 2.4-GHz for 802.11b and 802.11g networks.
The strength of the signal from the client.
The received noise level.
The signal-to-noise ratio in deciBels calculated from signal
strength and noise level.
FortiGate Version 3.0 MR5 Administration Guide
01-30005-0203-20070830 127