12.03.2015 Views

FortiGate Administration Guide - FirewallShop.com

FortiGate Administration Guide - FirewallShop.com

FortiGate Administration Guide - FirewallShop.com

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Router Dynamic<br />

RIP<br />

Figure 152:Basic RIP settings<br />

Delete<br />

Delete<br />

Edit<br />

RIP Version<br />

Advanced<br />

Options<br />

Networks<br />

Interfaces<br />

Delete and<br />

Edit icons<br />

Select the level of RIP <strong>com</strong>patibility needed at the <strong>FortiGate</strong> unit. You can<br />

enable global RIP settings on all <strong>FortiGate</strong> interfaces connected to RIPenabled<br />

networks:<br />

• Select 1 to send and receive RIP version 1 packets.<br />

• Select 2 to send and receive RIP version 2 packets.<br />

You can override the global settings for a specific <strong>FortiGate</strong> interface if<br />

required (see “Overriding the RIP operating parameters on an interface” on<br />

page 247).<br />

Select advanced RIP options. See “Selecting advanced RIP options” on<br />

page 246.<br />

The IP addresses and network masks of major networks (connected to the<br />

<strong>FortiGate</strong> unit) that run RIP. When you add a network to the Networks list,<br />

the <strong>FortiGate</strong> interfaces that are part of the network are advertised in RIP<br />

updates. You can enable RIP on all <strong>FortiGate</strong> interfaces whose IP<br />

addresses match the RIP network address space.<br />

IP/Netmask<br />

Add<br />

Enter the IP address and netmask that defines the RIPenabled<br />

network.<br />

Select to add the network information to the Networks<br />

list.<br />

Any additional settings needed to adjust RIP operation on a <strong>FortiGate</strong><br />

interface.<br />

Create New<br />

Interface<br />

Send Version<br />

Receive Version<br />

Authentication<br />

Passive<br />

Select to configure RIP operating parameters for an<br />

interface. These parameters will override the global RIP<br />

settings for that interface. See “Overriding the RIP<br />

operating parameters on an interface” on page 247.<br />

Select the interface to configure RIP operating<br />

parameters for.<br />

Select the version of RIP used to send updates through<br />

each interface: 1, 2, or both.<br />

Select the versions of RIP used to listen for updates on<br />

each interface: 1, 2, or both.<br />

Select the type of authentication used on this interface:<br />

None, Text or MD5.<br />

Select to block RIP broadcasts on this interface<br />

Delete or edit a RIP network entry or a RIP interface definition.<br />

<strong>FortiGate</strong> Version 3.0 MR5 <strong>Administration</strong> <strong>Guide</strong><br />

01-30005-0203-20070830 245

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!