FortiGate Administration Guide - FirewallShop.com

Viewing switch-LAN ports
Switch (FortiGate-224B only)
Configuring a switch-LAN interface
To configure a switch-LAN interface go Go to Switch > Port > Interface and
select the Edit icon for the Switch-LAN interface you want to reconfigure.
Figure 118:Switch-LAN interface settings
Name
Status
Mode
Native VLAN
Speed
Spanning Tree Protocol
Edge Port
The name of the switch port: fe01-fe24, ge25-26.
Enable or disable this switch port.
Select Access or Trunk mode.
Select the Native VLAN for this port.
Set to Auto, 10 or 100 Mb/s, full or half duplex, e.g., 100Full
Select Enable if the port connects to a single device and thus
cannot create a loop. It can enter the Forwarding state without
delay.
Link Type Select one of the following:
Shared LAN - a typical LAN with multiple devices
Point-to-Point LAN - a point-to-point link
Auto - type of link is determined automatically
802.1X Enable or disable 802.1X authentication on this port. For
complete 802.1X configuration, see “Configuring 802.1X
authentication” on page 226.
RADIUS VLAN assignment
Secure Port
Enable Secure Port if you want to create firewall policies to
govern the intra-VLAN traffic to and from this port. For
information about intra-VLAN firewall policies, see
“Configuring intra-VLAN firewall policies (FortiGate-224B
only)” on page 275.
FortiGate Version 3.0 MR5 Administration Guide
210 01-30005-0203-20070830