FortiGate Administration Guide - FirewallShop.com

System Maintenance
FortiGuard Center
Management & Analysis Service Options
This section displays your configuration options for the FortiGuard Management
and Log & Analysis services.
Select the blue arrow next to Log & Analysis Options to access this section.
Figure 112:FDN Log & Analysis options
Enter the Account ID you were given when you registered for your service or
services with Fortinet Support.
This section provides links to “Logging to a FortiGuard Analysis server” on
page 479 where you can configure your settings, and to purge your logs.
To configure how often to purge your logs, select how old the logs should be in
months before being purged.
Troubleshooting FDN connectivity
If your FortiGate unit is unable to connect to the FDN, check your configuration.
For example, you may need to add routes to the FortiGate routing table or
configure your network to allow the FortiGate unit to use HTTPS on port 443 to
connect to the Internet.
You might have to connect to an override FortiGuard server to receive updates.
See “To add an override server” on page 194. If this is not successful, check your
configuration to make sure you can connect to the override FortiGuard server
from the FortiGate unit.
Push updates might be unavailable if:
• you have not registered the FortiGate unit (To register your FortiGate unit, go
to Product Registration and follow the instructions.)
• there is a NAT device installed between the FortiGate unit and the FDN (see
“Enabling push updates through a NAT device” on page 196)
• your FortiGate unit connects to the Internet using a proxy server (see “To
enable scheduled updates through a proxy server” on page 195).
Updating antivirus and attack definitions
Use the following procedures to configure the FortiGate unit to connect to the
FortiGuard Distribution Network (FDN) to update the antivirus (including
grayware) definitions and attack definitions.
To make sure the FortiGate unit can connect to the FDN
1 Go to System > Status and select Change on the System Time line in the System
Information section.
2 Make sure that the time zone is set correctly for the region in which your FortiGate
unit is located.
3 Go to System > Maintenance > FortiGuard Center.
FortiGate Version 3.0 MR5 Administration Guide
01-30005-0203-20070830 193