FortiGate Administration Guide - FirewallShop.com

Customizing the display of log messages
Log&Report
uir
Note: The Detailed Information column provides the entire raw log entry and is only needed
if the log contains information not available in any of the other columns. The VDOM column
displays which VDOM the log was recorded in.
Filtering log messages
You can filter log messages by removing, adding or moving columns using the
Filter icon. By using the filter icon, you can display specific information of log
messages.
Figure 333:Log filters
Column Filter
Filter icon
The filter settings that are applied remain until you log out of the web-based
manager. Log filters automatically reset to default settings when you log into the
web-based manager.
Note: See “Adding filters to web-based manager lists” on page 43 for more information
about using the filter icons to filter log messages.
To filter log messages
1 Go to Log&Report > Log Access.
2 Select the tab to view logs from, Memory, FortiAnalyzer or FortiGuard.
3 Select a log type from the Log Type drop-down list.
4 Select the Filter icon in the column to view logs.
5 Select Enable to enable filtering for the column.
6 Enter the appropriate information in the appropriate fields.
7 Select OK.
8 Select the columns to filter in the Filter list.
You can also select the columns that display in the Filter list instead of selecting
the actual column.
You can view log messages in Raw format only after configuring the filters. If you
want to delete all filter settings, select the Clear All Filters link that displays at the
bottom of all filter setting dialog boxes.
FortiGate Version 3.0 MR5 Administration Guide
490 01-30005-0203-20070830