SECTION B - Derry City Council

More documents

Recommendations

Info

APPENDIX 4/1 ROAD RESTRAINT SYSTEMS (VEHICLE AND PEDESTRIAN) (Cont’d) Schedule of Road Restraint Systems (Vehicle and Pedestrian): Location Type of Road Restraint System (Preferred) Containment Performance Class Drawing Reference Road 1 verges Single Sided N2 GA/12 & GA/13 (precise alignment t.b.c. on site) Minimum Set-back (m) Maximum Working Width Other Requirements or Comments 0.6 W2; 0.8 m ASI A 186
APPENDIX 4/2: INFORMATION REQUIRED TO DEMONSTRATE COMPLIANCE OF ROAD RESTRAINT SYSTEMS TO BS EN 1317-1, BS EN 1317-2, BS EN 1317-3 AND DD ENV 1317-4 : 2002 The Contractor shall submit the following supporting information demonstrating compliance with BS EN 1317-1, BS EN 1317-2, BS EN 1317-3 and DD ENV 1317-4:2002 to the Project Manager for acceptance: EUROPEAN COMMITTEE FOR STANDARDISATION (CEN) COMPLIANCE Initial submission documents to be supplied for consideration of initial type test are as follows: 1. Test report in accordance with BS EN 1317-1, clause 8 (and including any additional test data required under BS EN 1317-3, clauses 7.3 and 7.4 and DD ENV 1317-4:2002, clauses 7.3 and 7.4) 2. Video/high speed film of test annotated showing date, test number and performance class. 3. Still photographs of complete installation including anchorage points. 4. Still photographs of vehicle before and after impact. 5. Full drawings of tested items. 6. Certification from the manufacturer that the item tested complies with drawings supplied. 7. Certificate from test house accredited in accordance with the requirements of Series 400 (MCHW 1.400). Additional information, which will be required on acceptance of initial type test prior to installation. 8. Manufacturer’s specification. 9. Installation drawings. 10. Manufacturer’s installation instructions including foundation requirements and test methods to verify their performance. 11. Manufacturer’s repair and maintenance manual. 12. Certificate of compliance with the Quality Management Scheme 1 for the Manufacture of Fencing Components. 2 13. Compliance with the Quality Management Sector Scheme 2 – Supply and Installation of Fences: (i) Section Scheme 2B for Vehicle Restraint Systems. 2 14. Certificate of compliance for the Quality Managements Section Scheme 5 for the Fabrication and Installation of Bridge Parapets and Cradle Anchorages. 3 : (i) Section Scheme 5A for The Manufacture of Parapets for Road Restraint Systems; and (ii) Sector Scheme 5B for The Installation of Parapets for Road Restraint Systems. 15. Nominal loads (direct forces, moments and co-existent shears) to be transferred from the parapet to the structure or foundation. 2&3 Notes: 1. All documents, which are not in English, will have to be translated. If they are in a language other than French or German the promoter will be required to supply a full translation. 2. Items 12 and 13 are required for safety barrier systems and transitions. 3. Items 14 and 15 are required for vehicle parapets. 187
Page 1 and 2:
SECTION B WORKS INFORMATION Part 1
Page 3 and 4:
1.0 PREAMBLE TO THE SPECIFICATION 1
Page 5 and 6:
Specification for Highway Works Sch
Page 7 and 8:
Specification for Highway Works Sch
Page 9 and 10:
2.0 SPECIFICATION APPENDIX 0/1: CON
Page 11 and 12:
110 5mm STEEL EDGING 120 5mm STEEL
Page 13 and 14:
530 FIRST CUT OF ALL GRASSED AND TU
Page 15 and 16:
540 UNDERGROUND GUYING OF SPECIMEN
Page 17 and 18:
Additional Clauses, Tables and Figu
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
• Contamination: Do not mix topso
Page 25 and 26:
o o Plant employed for transporting
Page 27 and 28:
750 IMPORTED BOULDERS (DONEGAL GREY
Page 29 and 30:
approved. o Size of Stone: Random s
Page 31 and 32:
140 EXCAVATION OF SUBGRADES • Fin
Page 33 and 34:
210 RESIN BOUND GRAVEL (FOR NEW VEH
Page 35 and 36:
o o o Loosening: - Light and noncoh
Page 37 and 38:
Q30 SEEDING/TURFING The Contractor
Page 39 and 40:
o Type: 'Floranid Master' slow rele
Page 41 and 42:
o 028 7775 0297 Properties of soil
Page 43 and 44:
Section 1 in the Cemetery and 15-30
Page 45 and 46:
Give notice before: o Setting out.
Page 47 and 48:
o o with a fibrous root system exac
Page 49 and 50:
290 SURPLUS MATERIAL o General: Rem
Page 51 and 52:
- Distance from wall: 300mm approx
Page 53 and 54:
502 PLEACHED TREES o Tree Pit Sizes
Page 55 and 56:
Feathered Trees. 585 BACKFILLING MA
Page 57 and 58:
Q40 FENCING 125 1100 MM HIGH MILD S
Page 59 and 60:
o Other requirements: Gates to be p
Page 61 and 62:
manufacturer’s specifications. Th
Page 63 and 64:
o Manufacturer: Haddonstone (as sup
Page 65 and 66:
Setting posts in concrete Standard:
Page 67 and 68:
Standard, EN shall be taken to mean
Page 69 and 70:
The steel is to be supplied to the
Page 71 and 72:
The mortar shall be mixed as thickl
Page 73 and 74:
with anti-corrosive treatments. Lig
Page 75 and 76:
Covered electrodes used shall give
Page 77 and 78:
15 TESTS OF MATERIALS The Steelwork
Page 79 and 80:
All weights and variations or other
Page 81 and 82:
The Steelwork Sub-Contractor shall
Page 83 and 84:
Dry film thickness: 75 micrometres.
Page 85 and 86:
APPENDIX 0/3: LIST OF NUMBERED APPE
Page 87 and 88:
Appendix 0/3 List A (Cont.) Volume
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
List ‘B’ gives the list of Cont
Page 95 and 96:
83473/03 83473/04 83473/05 Landscap
Page 97 and 98:
APPENDIX 0/5: SPECIAL NATIONAL ALTE
Page 99 and 100:
Cancelled Clauses Clause No. 801NIC
Page 101 and 102:
iv Unless otherwise specified all w
Page 103 and 104:
Sector Schemes 10. The application
Page 105 and 106:
APPENDIX AS QUALITY MANAGEMENT SCHE
Page 107 and 108:
BS EN 1436 BS EN 1463-1 BS EN 1463-
Page 109 and 110:
BS 4987 (11/03) Coated macadam (asp
Page 111 and 112:
(11/03) Lloyd’s Register Quality
Page 113 and 114:
SERIES 100 - PRELIMINARIES APPENDIX
Page 115 and 116:
• High speed mobile internet conn
Page 117 and 118:
APPENDIX 1/3: COMMUNICATION SYSTEM
Page 119 and 120:
APPENDIX 1/5: TESTING TO BE CARRIED
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138: APPENDIX 1/5: TESTING TO BE CARRIED
Page 155 and 156: APPENDIX 1/6: SUPPLY AND DELIVERY O
Page 157 and 158: 1.7.4 Excavation and sealing of iso
Page 159 and 160: APPENDIX 1/8: OPERATIVES FOR THE PR
Page 161 and 162: APPENDIX 1/9: CONTROL OF NOISE AND
Page 163 and 164: The Contractor and his designer wil
Page 165 and 166: APPENDIX 1/12: SETTING OUT AND EXIS
Page 167 and 168: Contractor, • including awaiting
Page 169 and 170: APPENDIX 1/14: MONTHLY STATEMENTS T
Page 171 and 172: APPENDIX 1/16: PRIVATELY AND PUBLIC
Page 173 and 174: 1.7 The Contractor’s attention is
Page 175 and 176: (signage and coning) a minimum of 3
Page 177 and 178: APPENDIX 1/23: RISKS TO HEALTH & SA
Page 179 and 180: APPENDIX 1/24 : QUALITY MANAGEMENT
Page 181 and 182: The Quality Plan shall be submitted
Page 183 and 184: APPENDIX 2/2: FILLING OF TRENCHES A
Page 185 and 186: Posts: 60 x10mm thick at top reachi
Page 187: APPENDIX 4/1 ROAD RESTRAINT SYSTEMS
Page 191 and 192: APPENDIX 4/2: INFORMATION REQUIRED
Page 193 and 194: APPENDIX 4/2: INFORMATION REQUIRED
Page 195 and 196: APPENDIX 5/1: DRAINAGE REQUIREMENTS
Page 197 and 198: APPENDIX 5/7 TERMOPLASTIC STRUCTURA
Page 199 and 200: APPENDIX 6/1 : REQUIREMENTS FOR ACC
Page 201 and 202: Table A6/1.1 (Continued): Acceptabl
Page 203 and 204: APPENDIX 6/3: REQUIREMENTS FOR EXCA
Page 205 and 206: APPENDIX 6/5: GEOTEXTILES USED TO S
Page 207 and 208: APPENDIX 6/7: SUB-FORMATION & CAPPI
Page 209 and 210: 5 Rock cutting areas are to be left
Page 211 and 212: APPENDIX 6/10: GROUND ANCHORAGES, C
Page 213 and 214: APPENDIX 7/1: PERMITTED PAVEMENT OP
Page 215 and 216: BS 4987.2005: Clause 7.4 SCA2, SCA3
Page 217 and 218: APPENDIX 7/2: EXCAVATION AND REINST
Page 219 and 220: APPENDIX 7/4 : BOND COATS, TACK COA
Page 221 and 222: APPENDIX 11/1 : KERBS, FOOTWAYS AND
Page 223 and 224: APPENDIX 17/1 : CONCRETE - CLASSIFI
Page 225 and 226: APPENDIX 17/4 : CONCRETE - GENERAL
Page 227 and 228: APPENDIX 25/2: REQUIREMENTS FOR REI
show all

SECTION B - Derry City Council

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?