Swift Owner's Handbook - Swift Group

Fault FindingWATER (continued)Problem Possible Cause RemedyWater flows from hot tapbut has reduced flow fromcoldCold water pipe kinked preventing flowBlockage in cold pipe lineCold tap not connectedCold tap failed or blockedIf a water filter is fitted, the cartridge is exhaustedCheck and re-route if necessaryDisconnect pipes after 1st Y connector and check up to tapRefer to installation instructionsDisconnect and inspectReplace cartridgeReduced flow from bothhot and cold tapsBattery condition low causing pump to run slowlyIf new taps have been fitted they may be restricting flowPump needs servicingPartially blocked pump filter or in-line filter, if fittedPump outlet pipe kinked restricting flowWater leakCheck battery state of charge, refer to electrical supply noteDisconnect and check that they have at least 1/4" (6.3mm) boreRefer to pump servicing instructionsDismantle and clean if necessaryCheck and re-route if necessaryCheck all water connectionsReduced flow fromeither tapY’ connector(s) fitted incorrectly Refer to installation instructionsPipe kinking restricting flowCheck and re-route if necessaryBore size difference in tapsUse taps of equal bore sizeWarm water flows out ofcold tapHot water back-feeding into cold line, usually if mixertap or single outlet hot and cold taps being usedFit non-return valve in cold supply, near tapIf pump motor runssteadily and will not stopBattery voltage may be too low (below 10.5 volts)Check that there is water in the containerAdjust switch and/or re-charge batteryCheck all connections in pipework103