Swift Owner's Handbook - Swift Group

Services8. Slide wire terminals off microswitch.9. Attach replacement microswitch andrelocate. Note: Ensure microswitch snapsfully home.10.Before relocating shroud ensure wires areneatly located in the front groove asshown.11.Replace shroud. Note: Ensure shroudlocating rib is aligned with the rear grooveof tap and snap fully home, ensuring clipsare retaining the shroud.12.Replace actuator in position noted in 4above.13.Replace lever and fix with screw.Note: Do not overtighten screw.14.Replace lever cap.WinterisingTo avoid damage as a result of freezing,drain the entire water system. To protect Elitetap or shower units, the tap control(s) andthe shower control should be opened whendraining the system to enable stored water inthe outlets to drain back through the controlvalves and out of the system. (Switch offpump at isolator). Ensure that both the hotand cold systems are fully drained bydraining separately. The cold drain plug is aseparate drain plug from the heater drainplug. The lever should be up and in thecentre to drain the hot and cold systemwhen not in use. Remove water filter if fitted.Please consult your dealer if in difficulty.If they are unable to solve the problem,contact Whale Customer Services:tel: 01247 270531 ext. 211 or 213.REICH ‘CHARISMA’ SINGLELEVER MIXER TAP1. Detach cover (1)2. Loosen screw (2) inside the handle3. Detach the handle (3)4. Turn out the rosette (4)5. Turn out the brass nut (5) with spannerSW 296. Pull out the ceramic cartridge (6)7. If the cartridge is defect please install anew one8. If the micro switch is defect please pullthe wire out of the mixer (7)9. Detach the cover (8) in front of the handle10.Loosen screw (9) inside the handle andpull-out the micro switch11.Install cartridge, micro switch, brass nut,rosette and handle in the opposite way3217Reich Charisma9 845625