Swift Owner's Handbook - Swift Group

ServicesNever allow the pump to run continuouslyfor more than 15 minutes.Note: When refilling the water container, thepump assembly may be left unplugged intothe wall socket so that the pump can be keptoff the ground by inserting the hose into thegroove on the underside of the plug. But, thepump assembly MUST be unpluggedBEFORE replacing the pump into the refilledwater container.WHALE ‘ELITE’ MICROSWITCHTAPSThe micro switch taps are used when thewater supply is not pressurised.When the tap is turned on the micro switch(which is fitted inside the tap) activates thepump to supply water.OperationSwivel the tap spout (a) to the desiredposition over the sink, lift the control lever (b)to activate the pump and allow water to flowsimultaneously. To adjust the temperatureswivel the lever (c) to the left or right asshown opposite.CleaningIt is recommended that a non-abrasive dampcloth is used for cleaning the EliteTap/Shower.Microswitch Replacement: A microswitchreplacement kit is available (ref. MT8000).24Note: Before commencing microswitchreplacement ensure instructions are readthrough thoroughly. The entire process canbe completed without the need to removethe tap from the worktop.Before you Start1. Ensure pump is isolated.2. Position lever in central, i.e. mixer, offlocation.Microswitch Replacement1. Carefully remove lever cap. A recess atthe back of the lever cap is provided toassist with this.2. Remove screw with No. 2 Poziscrewdriver. Note the position of the leverat this stage.ImportantNote position ofACTUATOR beforeremoving it.3. Lift off the lever.4. Note the position of actuator before removal.Flange should be facing forward.5. Remove actuator.6. To remove shroud, squeeze clips with onehand and slide shroud off with other hand.7. Remove microswitch, using finger andthumb, pull up and outwards.